Laserfiche WebLink
Project Info <br />Pro)ect Address <br />834 ea aT S.W. <br />Data 3/16/2006 <br />E VERETT NA. <br />For Building Department Use <br />Applicant Name, <br />eorx er vsNruRs L1c <br />Applicant Address: <br />320 106TH AW N.L. <br />Applicant Phone: <br />aLLLsvue, NA 9eoo4 <br />Project Description <br />❑ New Building I] Addition ❑ Alteration El Plans Included <br />Refer to WSEC Section 1513 for controls and commissioning requirements. <br />Compliance Option <br />O Prescriptive O Lighting Power Allowan e Q Systems Analysis <br />(See Qualification Checklist (over). Indicate Prescriptive 6 LPA spaces cluady, on plans.) <br />Alteration Exceptions <br />(check appropriate box) <br />❑ No changes are being made to the lighting <br />10 Less than 60% of the fixtures are now. and Installed fishing watlage is not being increased <br />Maximum Allowed Lighting Wattage (interior) <br />Location <br />(floornoom no <br />Occupancy Description <br />Allowed <br />Watts per 0° •• <br />Area In 02 <br />Allowed x Area <br />orrice <br />in orrice <br />1.00 <br />2885.0 <br />2885.0 <br />'• From Table 15.1 (over) • document all exceptions on form LTG-LPA Total Allowed Watlsi 2885.0 <br />Notes: <br />1. Use manufacturer's listed maximum Input waltatiq. For hardwired ballasts only, the <br />default table In the NREC Technical Reference Manual may also be used <br />2. Include exit lights unless less than 5 watts per fixture. <br />Proposed Lighting Wattage (Interi®t)st all fixtures. For exempt lighting, not exception and leave WaltslFixture blank. <br />Location <br />(floor/room no.) <br />Fixture Description <br />Numberof <br />Fixtures <br />WatIN <br />Fixture <br />Watts <br />Proposed <br />OPPIce <br />2x6 a To rLWPLaLNT rlxluve <br />31 <br />88.0 <br />2720.0 <br />Officz <br />Ix1 2-TeaR LITHORIA WRAP AROm1Or <br />2 <br />67.0 <br />134 .0 <br />Total Proposed Walls may not exceed Total Allowed Watts for Interior <br />Total Proposed Watts <br />2862.0 <br />Maximum Allowed Lighting Wattage (Exterior) <br />Allowed Wells <br />Area In h' <br />ed Waits <br />Location <br />Description <br />per A' or per If <br />for If fo eq <br />x It' (or x III <br />Covered Parking <br />(standard pam0 <br />e <br />Covered Parking <br />2 <br />0.3 Wm <br />(reflective paint) <br />Open Parking <br />0.2 Wine <br />Outdoor Areas <br />0.2 W111s <br />Bldg. (by facade) <br />0.25 Will" <br />Bld r m) <br />1.5 WAt <br />Note: lot building extenor, choose either the facade area or the perimeter method, but not both) Total Allowed WattslI <br />Use mlgr listed maximum Input wallage. For fixtures win hard vAreu DallaSus only,-1 <br />Proposed Lighting Wattage (Exterior) the default table In the NREC Technical Reference Manual may also be used. <br />Location <br />Fixture Description L <br />Numberof <br />Fixtures <br />Watlal <br />Proposed <br />Total Proposed Walls may not exceed Total Allowed Walls for Exterior 1 olal Proposed Watts <br />