Laserfiche WebLink
MAYES TESTING ENGINEERS, INC. Seaft office <br /> 20225 Cedar Va':�y Road <br /> Suite 110 <br /> Lynt-wood,WA 98036 <br /> Project No. L13380 , ph 425.742.9360 <br /> fax425.745.1737 <br /> Project Boardwalk Condominiums Foundation Repair <br /> Address 615 75th Street SE, Everett, WA f Ta=naORice <br /> Permit No. B1307-013 �"` SUeE-.TaoomaWay <br /> .L Suite E-2 <br /> Bldg Dept. Everette Tacorr,a,WA98499 <br /> ph 253.584.3720 <br /> Owner Quorum Real Estatefax 253.5B4.3707 <br /> Architect SCR Architects Putkv,aofte <br /> Engineer Coughlin Porter Lundeen <br /> 7911 NE 90 <br /> Contractor T-OZ Construction Portland,OR 97211 <br /> ph 503.281.7515 <br /> fax 503.281.7579 <br /> Record No. 005 <br /> Date 10/21/2013 <br /> Weather ---- <br /> Inspection Structural Steel and Proprietary Anchors <br /> Sample(s) N/A <br /> Reported to site and met with contractor for the scheduled epoxy inspections. Found contractor <br /> not ready. Performed inspection of bearing plates, both the 6" x 6" with one stud and the 12" x 12" <br /> with four studs as per SSK-02 and detail 9 on S1. Found the bearing plates could be eitherwelded <br /> to pin piles or set over piles with a 4" sleeve. The sleeve option was utilized. Noted the 6" x 6" <br /> plates had a 3/4" diameter stud in place of the called out 1/2" diameter. All welds were acceptable. <br /> For the 12" x 12" plates, found 3" studs were used in place of the 3-1/2" per detail 9. Discussed <br /> this with Cory Hitzeman and this was acceptable. Discussed epoxy requirements with contractor— <br /> cleaning and reinforcing bar layout per plans. Contractor is to reschedule epoxy when ready. <br /> To the best of our knowledge, all items inspected today are in conformance with approved plans <br /> and specifications. <br /> Inspector: M. Mattox <br /> Reviewed By: <br /> Michael S. Dolder, P.E. <br /> Vice President <br /> Information in this report applies only to the actual items inspected or tested and shall not be reproduced except in full,without the approval of Mayes Testing Engineers.Inc. <br /> Page 1 of 1 <br />