11323 EVERGREEN WAY 2017-05-23 - Laserfiche WebLink

Special Provisions for Highway Encroachments Permit No. 50655 Applicable provisions are denoted by ® 1. No work provided for herein shall be performed until the Permit Holder is authorized by the following Department representative: Mike Gallop, Const. Representative gallopm@wsdot.wa.gov Office 206-440-4913 Cell 206-940-2736 02. Prior to the beginning of construction,a preconstruction conference shall be held at which the Department and the Permit Holder and Permit Holder's engineer,contractor,and inspector shall be present. ® 3. Should the Permit Holder choose to perform the work outlined herein with other than its own forces,a representative of the Permit Holder shall be present at all times unless otherwise agreed to by the Department representative. All contact between the Department and the Permit Holder's contractor shall be through the representative of the Permit Holder. Where the Permit Holder chooses to perform the work with its own forces,it may elect to appoint one of its own employees engaged in the construction as its representative. Failure to comply with this provision shall be grounds for restricting any further work by the Permit Holder within the State right of way until said requirement is met. The Permit Holder,at its own expense,shall adequately police and supervise all work on the above described project by itself,its contractor,subcontractor,agent,and others,so as not to endanger or injure any person or property. ® 4. A copy of the permit must be on the job site and protected from the elements at all times during any of the construction authorized by said permit. 05. This permit does not give the Permit Holder or any agent or contractor of the Permit Holder any rights to cut,spray,retard,remove,destroy, damage,disfigure or in any way modify the physical condition of any vegetative material located on the highway right of way,except by written permission from the Department or for purposes as described by No.6 if denoted below. All restoration shall be done to the satisfaction of the Department at the sole expense of the Permit Holder. ® 6. If necessary to increase sight distance,brush shall be removed from both sides of the access connection and stumps shall be removed. The indiscriminate cutting of merchantable timber or disfiguring of any feature of scenic value shall not be permitted. ® 7. The access connection(s)shall be constructed in accordance with the attached WSDOT approved template Sufficient length of diameter culvert pipe shall be placed in ditch and laid to a true line and grade. The access connection(s)shall be surfaced to the limits as shown on the plan with a 150 millimeter(6 inch)minimum compacted depth of gravel base material and a 80 millimeter(3 inch)compacted depth of crushed surfacing top course. Asphalt paving will not be required.Finished grade of the access connection shall be in accordance with the profile control as shown on the attached plan.Directing of surface water from private property to Department right of way will not be permitted,unless otherwise approved by the Department. 8. The access connection(s)shall be constructed in accordance with the attached Sufficient length of diameter culvert pipe shall be placed in ditch and laid to a true line and grade. The access connection(s)shall be surfaced to the limits as shown on the plan with a 150 millimeter(6 inch)minimum compacted depth of gravel base material,a 80 millimeter(3 inch)minimum compacted depth of crushed surfacing top course,and paved with a 80 millimeter(3 inch) minimum compacted depth of Asphaltic Concrete Class B unless otherwise specified by the Department. Any existing oil mat on shoulder or roadway shall be removed and new pavement laid to a butt joint with existing pavement. Finished grade of new pavement shall be in accordance with the profile control as shown on attached plan. Directing of surface water from private property onto Department right of way will not be permitted,unless otherwise approved by the Department. (09. All buildings and appurtenances shall be so located at a distance from the right of way line of any State Highway that none of the right of way therefore is required for use of the patrons or customers of any such establishment. Permit Holder shall comply with local building codes. Set-back requirements for the location of buildingts in relation to the right of way line are a function of local authorities,and they should be consulted regarding requirements that must be adhered to. RAMPS-Special Provisions-Pagel Page 1 3 ' i Exhibit „A„