Reece Construction Company Inc. 5/24/2017

CITY OF EVERETT SPECIAL PROVISIONS Supplement 1-05.3 as follows: The Contract Documents include Plans that show such details as are reasonably necessary to give a comprehensive understanding of the Work. The Contractor shall submit alterations affecting the requirements and information in the Plans in writing to the Engineer for approval prior to performing such Work. The Engineer may supplement the Plans with additional drawings and explanations, consistent with the purpose and intent of the original Plans, to detail and illustrate the Work. The Contractor shall perform the Work according to these supplemental drawings and explanations. In addition to supplemental drawings furnished by the Engineer, the Contract Documents may also be supplemented by Type 1, Type 2 or 2E, and Type 3 or 3E Working Drawings prepared by the Contractor, material supplier, or manufacturer, when necessary or as required by the Contract Documents to detail and illustrate portions of the Work. All types of Working Drawings shall be reviewed by the Engineer before work pursuant to those Working Drawings is performed. Type 3 and 3E Working Drawings may include, and not be limited to, shop details, erection plans, masonry lay-out diagrams, reinforcing steel and bending diagrams, post tensioning plans, shoring, cribbing, cofferdam, or falsework plans, formwork plans, or hydraulic items. Type 2 and 2E Working Drawings may include, and not be limited to, Catalog cuts or standard plans for commonly used manufactured items. The Contractor shall be fully responsible for the accuracy of dimensions and details on Working Drawings, and for complete conformity with the Contract Documents, even if the Working Drawings have been approved by the Engineer, or if the Contractor and the Engineer agree on dimensions and details. The City does not accept Working Drawings as accurate or adequate, and does not take responsibility for, or warrant that Working Drawings will meet Contract requirements. Engineer's review of Working Drawings shall not relieve Contractor from responsibility for variation from the requirements of the Contract Documents unless Contractor has in writing called the Engineer's attention to each such variation at the time of submission, and the Engineer has given written approval of each such variation by a specific written notation thereof incorporated in or accompanying the returned Working Drawing; nor will review by Engineer relieve Contractor from responsibility for errors or omissions in the Working Drawings or from responsibility for having complied with the provisions of this section. Submittal requirements may be found in 1-05.3(1) or elsewhere in these Special Provisions. Deviations from Standard Plans will be subject to a Working Drawing submitted by the Contractor and approved by the Engineer. Where a Working Drawing is required by the Specifications, related Work performed prior to completion of the Engineer's review of the pertinent submission will be the sole expense and responsibility of the Contractor. Supplement 1-05.3 by adding the following: 1-05.3(1) Submittals (******) Where required by the Contract Documents, the Contractor shall submit information, such as Working Drawings that will enable the City's Representative to advise the City whether the Contractor's proposed materials, Equipment or methods of work are in general conformance to the design concept and in compliance with the Plans and Specifications,. Approval or acceptance of a Submittal does not relieve Contractor Water Main Replacement R Division 1 —GENERAL REQUIREMENTS March 1, 2017 WO No—UP3646 SP-54