Ordinance 2923-06 - Laserfiche WebLink

permitted outside the areas designated by map number 22-2 when approved by the planning director, using Review Process II after consultation with and approval by the city engineer. Is hereby amended to read: 22.020 Development standards in the B-3 zone. In addition to the development standards contained in Table 6.1 in Chapter 6 of this title, the following development standards apply to uses hereafter established in the B-3 zone: A. Required Setbacks. There shall be no minimum setbacks in the B-3 zone. However, no portion of a setback area located between a building and the public sidewalk shall be permitted to be used for off-street parking. B. Height of Building or Structure. 1. Except as otherwise provided by this section, buildings located within the B-3 zone shall be permitted to have a height no greater than indicated on map number 22-1. 2. Building height in the B-3 zone is measured as the height above the highest point of any public sidewalk immediately contiguous to the lot upon which the building is proposed to be located. 3. Buildings may exceed the height limits indicated on Map #22-1 as follows if approved by the Planning Director, using Review Process II, as provided herein: a. If a project includes 3 or more of the bonus elements listed in Subsection E of this Section, it may exceed the height limit: 1) with no maximum height limit in the Colby Ridge (200 feet) area indicated on Map 22-1; 2) by fifty percent of the height limit indicated for all other areas. b. All floors with a finished floor elevation above 40 feet in height shall be less than 150 feet in width measured in the north -south direction.