Laserfiche WebLink
2015 Washin ton State E Code Com liance Forms for Commercial R d R3 over 3 stories and all R1 <br /> , ' General Instructions: <br /> A. Include all fans directly associ��ted with the delivery and removal of conditioned air to the zones served by the system.Enter CFM and brake <br /> horsepower(bhp)of each fan at peak design conditions and the nameplate horsepower(hp). Include supply,return and relief fans,exhaust <br /> and exhaust hood fans(>1 hp), booster fans and fans included as part of make-up air units,dedicated outside air systems(DOAS),energy <br /> recovery ventilators(ERV),anci series fan-powered terminal equipment. <br /> 8. VAV parallel fan-powered terrn,inals and economizer relief fans do not need to be included if the fans do not operate at peak conditions. <br /> C. Fans not directly associated with the delivery and removal of conditioned air, such as condenser fans, do not need to be included in the fan <br /> power total. <br /> D. Fan power calculations are nof required for non-central air HVAC systems such as 4-pipe fan coils and variable refrigerant flow(VRF)systems <br /> unless individual fan systems eire greater than 5hp. <br /> E. In the Brake HorsepowerAllowance Adjustments table, if a Device Type is se/ected that has an Assigned Pressure Drop, this value will autofill <br /> into the Assigned Pressure Drop cell and the Calculated Pressure Drop cell will be write-protected. If the Device Type requires a Calculated <br /> Pressure Drop, then enter this value into the Calculated Pressure Drop cell and the Assigned Pressure Drop cell with be write-protected. <br /> F. Refer to FAQ section of MECh'-FANSYS-DOC for additional instructions. <br /> � <br /> � .� <br /> �� l <br />