2818 HEWITT AVE KATANA SUSHI 2018-01-09

April 12, 2016 BIGLj.JND LLC 2818 Hewitt Ave Katana Sushi Type I Hood Permit: M 1510-060 Corrections letter: 1) Remove wood framing above hood and 18" in all directions from the hood. Replace with non-combustible framing materials above hood and 18" in all directions of the hood. You may use one of the clearance reduction methods in Table 308.6. Inspector will need to verify the non-combustible wall framing and the non-combustible overhead framing before you cover. 5079 IMC-A Type I Hood shall be installed with a clea�ance to combustibles of not less than 18 inches. Table 308.6 allows for a �eduction to the 18"clearance. 2) The grease duct wrap is not installed per the manufacturer's specs. Remove the wrap and call for a light test inspection before you re-install the 3M Wrap. Remove the spray foam around the grease duct wrap at the roof level. After the light test inspection you can re-install the fire wrap following the manufacturer's instructions. Please call for inspection of the fire wrap. 3) Install hangers on the make-up air. SI0.9 IMC—Ducts shall be supported at inte�vals not exceeding 1 D feet. Supports shall be const�uct�c�'of nonco�nUustible mater•ial. 4) Location of the fan is not code compliant. 506.3.13.3 IMC—Exhaust outlets shall be located not less than 10 feet ho�izontally fi�om pa��ts of the saine o� contiguous buildings, adjacent buildings and adjacent p�ope�ty lines and shall be located not less than 10 feet above the adjoining grade level. Exhaust outlets shall be located not less tltan 10 feet ho�izontally from o� not less than 3 feet above ai� intake openings into any building. Exception: Exhaust outlets shall te�minate not less than S feet horizontally from pa�ts of the same or� contiguous building, an adjacent building, adjacent prope�ty line and ai� intake openings into a building whe�e air f�orn the exhaust outlet discha�ges away f�om such locations.