2927 WETMORE AVE 2018-02-12 - Laserfiche WebLink

Exterior Li • htin • LTG-EXT 2015 Washington State Energy Code Compliance Forms for Commercial Buildings including R2,R3,R4 over 3 stories and all R1 Revised August 2016 Project Title: NARRATIVE COFFEE Date 2/13/17 Exterior Lighting For Building Department Use OZone 1 ZcO2 Zone 30 (one 4 Zone Table C40.5.5.2(1)ion. Zone selection required to enable LTG-EXT form Specified by jurisdiction. Calculation Area O Additior�tand edition alone existing Alteration with<50% Alteratiggk�with>_50%ext. Oext.wattage replaced wattagellplaced — Building Grounds [fficacy>80 lumens/watt Exemption Applies to luminaires> 100 Watts Dontrolled by motion sensor Tradable Maximum Allowed Lighting Wattage NOTE' Base Site Allowance: 1300 Area(ft),perimeter(If) Allowed Watts Allowed Watts Tradable Surfaces Surface Description or#of items per ft2 or per If x ft2(or x If) Entry Canopies Soffitted area above main entry door 126 0.9 W/ft2 50 Other Entry Door Rear door emergency lighting 3 20W/LF door 60 Total Allowed Tradable+Site Allowance Watts: 1411 Tradable Proposed Lighting Wattage NOTE 2 Number of Watts per Watts Tradable Surface Fixture Description NOTE 3'a Fixtures Fixture NOTE S _ Proposed Entry Canopies A3,Can Light,Compact Fluorescent 3 75 225 Other Entry Door Rear door emergency lighting,LED 1 50 50 Total proposed tradable watts may not exceed the sum of total allowed tradable watts Total Proposed Tradable Watts: 275 plus the base site allowance. Any base site allowance not needed to make tradable watts comply can be applied to individual non-tradable categories. Non-Tradable Maximum Allowed Lighting Wattage NOTE' Site Allowance Remaining: 1300 Area(ft2),perimeter(If) Allowed Watts Allowed Watts Non-Tradable Surfaces Surface Description or#of items per ft2 or per If x ft2(or x If) Non-Tradable Proposed Lighting Wattage NOTE 2 Number of Watts per Watts Non-Tradable Surface Fixture Description NOTE 3,a Fixtures Fixture NOTE 5 Proposed Non-tradable proposed watts may not exceed allowed watts for any individual surface Non-Tradable Watts Exceeding LPA: 0 unless the total excess watts for all non-tradable surfaces are less than the remaining site allowance. Remaining Site Allowance: 1300 Exterior Lighting C C l 1'. T C i M. .X n L C ,'‘i A .F E Note 1-List all unique exterior sufaces per Table C405.5.2(2)that occur in the project scope. Select exterior surface categories from drop down menu. Note 2-List all proposed lighting fixtures including existing-to-remain fixtures. Note 3-For proposed Fixture Description,indicate fixture type,lamp type,number of lamps in the fixture,and ballast type(if applicable). Note 4-Existing-to-remain fixtures shall be included in the Tradable and Non-Tradable Proposed Lighting Wattage tables in the same manner as new fixtures. Identify as existing in fixture description. Note 5-For proposed Watts/Fixture enter the luminaire wattage for installed lamp and ballast using manufacturer or other approved source.For luminaires with screw-in lamps,enter the manufacturer's listed maximum input wattage of the fixture(not the lamp wattage).For low voltage lighting,enter the wattage of the transformer.