Laserfiche WebLink
111 <br /> MiTek° <br /> MiTek USA, Inc. <br /> 250 Klug Circle <br /> Corona,CA 92880 <br /> 951-245-9525 <br /> Re: B-16-01036 <br /> JAMES AND RACHELLE NEAMTIU <br /> The truss drawing(s)referenced below have been prepared by MiTek USA,Inc. under my direct supervision <br /> based on the parameters provided by Roof Truss Supply. <br /> Pages or sheets covered by this seal: K2171222 thru K2171244 <br /> My license renewal date for the state of Washington is January 2,2017. <br /> Lumber design values are in accordance with ANSI/TPI 1 section 6.3 <br /> These truss designs rely on lumber values established by others. <br /> 01ONIO kt <br /> GQS���WAS44 4 <br /> ,c) <br /> � <br /> 49639.,/�Q,`� <br /> ate, GISTfSR- � <br /> ✓✓`rSONAL0 <br /> July 14,2016 <br /> Hernandez,Marcos <br /> IMPORTANT NOTE:The seal on these truss component designs is a certification that the engineer named is licensed <br /> in the jurisdictions(s)identified and that the designs comply with ANSI/TPI 1. These designs are based upon parameters <br /> shown(e.g.,loads,supports,dimensions,shapes and design codes),which were given to MiTek.Any project specific <br /> information included is for MiTek's customer's file reference purpose only,and was not taken into account in the preparation <br /> of these designs. MiTek has not independently verified the applicability of the design parameters or the designs for any <br /> particular building.Before use,the building designer should verify applicability of the design parameters and properly <br /> incorporate these designs into the overall building design per ANSI/TPI 1,Chapter 2. <br />