3003 W CASINO RD BLDG 40-37 2018-09-21

�' �� S Fire Safety Z Strobes, Horns, Horn/Strobes ENGINEER AND ARCHITECT SPECIFICATIONS • UL listed. ULC, CSFM, and FM pending. • ADA/NFPAcom liant � ' �.�a��v P �v �. � • EZ Mount design,with separate base plate, provides ability to pre-wire the base and test the circuit wiring before the walls are covered • The base plate is protected by a disposable cover and the Series ZH appliances can quickly snap onto the base after the walls are painted. • EZ Mount Universal Mounting Plate(ZBB)—uses sing�e �1R� � plate for ceiling and wall mount installations '��.. • Wall Mount models feature field selectable candela settings ` '`s . of 15/30/75/110cd and 135/185cd • Ceiling Mount models feature field selectable candela Series ZR settings of 15/30/75195cd and 115/177cd ��:�� • Strobes can be synchronized using the Siemens DSC sync �, '� ' � �� modules, FS-250 panel,XLS panel, or PAD-3 power supply � � with built-in sync protocol �4' ----= �' ;` • "Special Applications"listed with Siemens panels „� �'�-��p �s�' ��y a :��;, , • Strobes produce 1 flash per second �. • Selectable Continuous Horn or Temporal(Code-3)Tones with selectable 90 or 95 dBA setting(ZH model) ZR AND ZH Mounting Description Engineering Specifications The Siemens Series Z notification appliances feature an General easy snap on base that is designed to simplify the instal- Audible/visual notification appliances shall be listed for lation and testing of horns, strobes, and horn/strobes. indoor use and shall meet the requirements of FCC Part The separate Series Z snap on base can be pre-wired so �5 Class B. These appliances shall be listed under UL circuit wiring can be fully tested before the appliance is Standard 1971, (Standard for Safety Signaling Devices installed and before the walls are covered. Once all sur- for Hearing Impaired) and UL Standard 464 (Fire Protec- rounding work is complete, the appliance can be simply tive Signaling). The appliances shall use a universal installed by snapping it on the base. Shorting contacts in backplate that shall allow mounting to a single-gang, the base, which provide continuity for circuit testing,are doubfe-gang, 4-inch square, 4" octal, or a 3-1/2"octal permanently opened when the appliance is installed so backbox. Two wire appliance wiring shai! be capable of any subsequent removal of the appliance wi{I indicate a directly connecting to the mounting back plate. Conti- trouble condition on that circuit at the control panel when nuity checking of the entire NAC circuit prior to attach- circuit supervision is enabled. The same base is used for ing any audible/visual notification applianees shall be all Series Z horns, strobes and horn/strobes to provide allowed. A dust cover shall fit and protect the mounting consistent installation and easy replacement of appli- plate. The dust cover shall be easily removed when the ances if required.A locking screw is also included for the appliance is installed over the backplate. Removal of appliance to provide extra secure installation. an appliance shalf result in a trouble condition by the The Siemens Series Z appliances incorporate the same Fire Alarm Control Panel(FACP). dependable circuitry and high efficiency optics that are Strobes used in Siemens ST strobes, NS horn/strobes and NH horns and have the same high performance ratings. The Strobe appliances shall produce a minimum flash rate Series Z appliances are"Special Applications" listed with of 60 flashes per minute(1 flash per second) over the Siemens panels. Regulated Input Voltage Range and shall incorporate a CATALOG SHEET25gq,