3003 W CASINO RD BLDG 45-12 2018-09-20

, Lighting, Motor, and T isformer Permit Documen Checklist LTG-CHK 2012 Washington State Energy Code Compliance Forms for Commercial Buildings including R2&R3 over 3 stories and all R1 Revised Jan 2014 Project Address BOEING ED Static Test Bldg Date 9/3/2015 The following information is necessary to check a permit application for compliance with the lighting,motor,and transformer requirements in the Washington State Energy Code,Commercial Provisions. Applicability Location in Building Department (yes,no,na) Code Section Component Compliance information required in permit documents Documents Notes LIGHTING CONTROLS(Section C405.2) Indicate on plans the manual control type&locations served; 1E10-10 TO 1E10- Yes C405.2.1.1 Manual interior 15 C405.2.1.2 lighting controls Indicate of plans the 50%lighting load reduction method 1E10-10 TO 1E10- provided or identify exception taken 15 Indicate lighting system automatic shut-off capability-identify 1E10-10 TO 1E10- lighting zone areas served on plans; 15 Automatic time Indicate locations of override switches on plans and the areas 1E10-10 TO 1E1 0- Yee C405.2.2.1 switch controls and override switching served,include area sq.ft.; 15 Indicate locations where automatic shutoff is provided by other 1E10-10 TO 1E1 0- methods E10- methods(occupancy sensor,daylight controls,etc) 15 Yes C405.2.2.2 Occupancy sensors Indicate on plans the locations served by occupancy sensors 1E10-10 TO 1E10- 15 Daylight zones- Indicate vertical fenestration primary and secondary daylight 1E10-10 TO 1E1 0- Yes E10- Yes C405.2.2.3 Vertical fenestration zone areas on plans,include sq.ft.; 15 and skylights Indicate skylight daylight zone areas on plans,include sq.ft. Indicate on plans the locations served by daylight zone 1E10-10 TO 1E10- Yes C405.2.2.3.2 Daylight zone controls; 15 controls Indicate in plans the lighting load reduction(dimming)method- 1E10-10 TO 1E10- stepped or continuous dimming 15 Specific application Indicate on plans the locations served by specific application NA C405.2.3 lighting controls lighting controls General Indicate lighting control method for display and accent lighting, and display case lighting; NA C405.2.3- Display and accent Items 1&2 lighting Indicate these fixtures are controlled independently from both general area lighting and other lighting applications within the same space C405.2.3 Hotel/motel guest Provide a lighting control device at each guest room entry for NA Item 3 rooms all permanently installed fixtures in guest room; Indicated whether lighting control is manual or automatic NA C405.2.3- Supplemental task Provide automatic shut-off vacancy controls for supplemental Item 4 lighting task lighting,including under-shelf or under-cabinet lighting Identify eligible non-visual applications and method of lighting control; NA C405.2.3- Lighting for non- NA - - Item 5 visual applications Indicate these fixtures are controlled independently from both general area lighting and other lighting applications within the same space Indicate lighting control method for lighting equipment for sale C405.2.3- Lighting equipment or demonstration; NA for sale or Indicate these fixtures are controlled independently from both Item 6 demonstration general area lighting and other lighting applications within the same space If egress lighting power density is greater than 0.05W/ft2, 1E10-10 TO 1E10- C405.2.3 Means of egress indicate method of automatic shut-off during unoccupied 15 Yes periods; Item 7 lighting Identify on plans the egress fixtures that function as both 1E10-10 TO 1E10- normal and emergency means of egress illumination 15 C405.10 Cooler and freezer Provide vacancy device or timer to turn off fixtures within 15 NA minutes of unoccupancy for cooler and freezer lighting fixtures C405.11 lighting with lamp efficacy less than 40 lumens per watt Yes C405.2.4 Exterior lighting Indicate on exterior lighting plans the automatic lighting control 1E10-10 TO 1E10- controls method and locations served 15 Exterior building Provide motion sensor controls for building grounds fixtures 1E10-10 TO 1E10- Yes C405.6.1 grounds lighting rated at greater than 100 watts with lamp efficacy less than 60 15 controls lumens,or identify exception taken Identify applicable commissioning documentation requirements per Section C408 or eligibility for exception; Lighting system Provide written procedures for functional testing of all NA C408.3 functional testing automatic controls and describe the expected system response; Identify in construction documents the party responsible for functional testing of automatic lighting controls