3003 W CASINO RD BLDG 45-12 2018-09-20

Seatronics,Inc.Job#111008 BOEING EVERETT 45-12 BLDG.STATIC TEST FACILITY PHASE 2 Acceptance Test Procedure FIRE ALARM SYSTEM MODIFICATIONS&ADDITIONS Page 2 of 6 3.4 After the ATP is satisfactorily completed and all exceptions have been cleared, the Owner's Representative shall sign the "Approved and Accepted" block. 3.5 The Contractor's Field Engineer shall be responsible for the organization and performance of this accepted test. 3.5.1 The Contractor shall provide all material and equipment required to perform the test except as noted below: 4.0 TEST PREPERATIONS 4.1 EQUIPMENT REQUIRED 4.1.1 Test gas, Digital Volt Meter 4.2 TEST CONDITIONS - GENERAL 4.2.1 Notify interested parties that system tests are beginning. 4.2.2 Verify that all required system pre-tests have been completed. 4.2.3 Visually inspect equipment installation to verify proper mounting. 4.2.4 Verify that the system is in normal supervisory condition (power lamp is "on" and other lamps and audible devices are "off°). 5.0 ACCEPTANCE TESTS -ALARM & SUPERVISORY CONDITIONS 5.1 Verify alarm and supervisory conditions as specified in Table 1. For each alarm condition listed, the appropriate system response should occur. After initiation of each alarm or supervisory condition, the following steps should be completed: 5.1.1 Alarm condition -silence audible alarms (if activated) by pressing Alarm Acknowledge button, followed by the Alarm Silence button. 5.1.2 Supervisory condition - silence panel Supervisory audible by pressing Supervisory acknowledge control button. 5.1.3 Reset the control panel after the alarm condition system response(s) have been verified.(Do not reset if the test step specifically indicates not to reset) The system trouble lamp and audible trouble alarms will be"on". 5.1.4 Verify the control panel is in normal supervisory condition and all trouble indications have been cleared.