3402 MCDOUGALL AVE SNO CO PW 2018-11-14

• • • • • � ' � • 2015 Washington State Energy Code Compliance Forms for Commercial Buildings including R2,R3,R4 over 3 stories and all R1 Revised August 2016 Project Title: McDougall Date 2/26/2017 The following information is necessary to check a permit application for compliance with the lighting,motor,and electrical requirements in the Washington State Energy Code,Commercial Provisions. Applicability Location in Building Department (yes.no,na) Code Section Component Compliance information required in permit documents Documents Notes INTERIOR LIGHTING POWER&EFFICACY Include all luminaires in lighting fixture schedule;indicate fixture types,lamps,ballasts,and manufacturer's rated watts per E.01 fixture; C405.4.1 Identify spaces eligible for lighting power exemption on pians Yes C405.4.1 Total connected and in compliance forms;indicate the exception applied; --- -- --------- — _ ------------ -----__ — -- — -------- C405.4.2 interior lighting power ldentify tighting equipment eligibie for lighting power exemption in fixture schedule and in compliance forms;indicate the exception applied; Indicate that exempt lighting equipment is in addition to general area lighting and is controlled independentiy Indicate location of exit signs on plans and rated watts per res C405.3 Exit Signs E2.0 fixture in lighting fixture schedule(maximum 5 watts per fixture) If high e�cacy exception is applied to permanently installed lighting fixtures in dwelling units,indicate in lighting fxture NA C405.1 Lighting in dwelling schedule if lamps in fixtures are high effcacy per R404.1. units-lamp efficacy Calculate percentage of fixtures with high e�cacy lamps in project(min 75%to comply with exception). Reduced lighting For project with dwelling units,to comply with additional power density- e�ciency package option indicate in lighting fixture schedule if NA C406.3 lamps in fixtures have e�cacy rating of 60 lumens per watt or dwelling unit lamp more.Calculate percentage of fxtures with lamps that have this e�cacy effcacy rating(min 95%to comply with option). Lighting Power Calculation-Indicate compliance path taken Building Area Complete required compliance forms—proposed wattage per NA C405.42.1 building area does not exceed maximum aliowed wattage per Method building area.Identify locations of building areas on plans Complete required compliance forms—total proposed wattage Yes C405.422 Space-By-Space does not exceed maximum allowed wattage.Identify locations o E2.0 Method space types on plans,including retail display areas,lobby art& exhibit display areas,and ceiling heights as applicable To comply with additional efficiency package option, Reduced lighting demonstrate in compl�iance forms that total connected interior N7+ C406.3 lighting wattage is 75/o less than the total maximum allowed power density �ighting wattage via Building Area Method or Space-By-Space Method EXTERIOR LIGHTING POWER&EFFICACY Include all luminaires in lighting fxture schedule;indicate fixture types,lamps,ballasts,and manufacturer's rated watts per fixture; ------------------------ -------- --------- Totai connected Identify exterior applications eligible for lighting power NA C405.5.2 exterior lighting exemption on plans and in compliance forms;indicate exceptio power appiied;_ Indicate that exempt exterior lighting is controlled independently from non-exempt exterior lighting;include exception claimed for each fixture or group of fi�ures under exception category NA Table Exterior lighting zone Indicate building exterior lighting zone as defined by the AHJ C405.5.2(1) Exterior building For building grounds fixtures rated at greater than 100 watts NA C405.5.1 that are complying based on efficacy,indicate rated lamp grounds lighting efficacy(in lumens per watt)in fixture schedule Exterior lighting Complete required compliance form—proposed wattage for NA C405.52 exterior lighting plus base site allowed does not exceed power calculations maximum allowed ; � l�� �