Laserfiche WebLink
PUBLIC WORK. <br /> July 27, 2017 <br /> Bruce Dunn <br /> 15049 NE Bell-Red Road <br /> Bellevue, WA 98007 <br /> Email: bdunn@cja-inc.com <br /> Owner: Sharon Wilcox <br /> Job Address: 2727 Colby Ave <br /> Plan Check No: B1707-034 <br /> RE: Corrections Letter <br /> Dear Mr. Dunn, <br /> In response to the application for a building permit, the plans have been examined and you are <br /> advised that revisions may be necessary before a permit can be issued. Please review and <br /> respond to the comments below. <br /> In order for the processing of your application to continue, it will be necessary to provide the <br /> Building Division with two new sets of revised construction documents reflecting the corrections <br /> requested. Please include a response letter which indicates how the corrections were resolved. <br /> General <br /> . The exterior seating is being reviewed by the Public Works development reviewer and is <br /> 7") <br /> not part of this (building) review. <br /> ▪ The City of Everett has an ordinance that regulates grease accumulation and removal, <br /> which is administered through the Industrial Pretreatment division of Public Works (IPT). <br /> I have contacted that division on behalf of the project regarding the possibility of a <br /> (minimum 750 gallon) required grease interceptor. The preliminary response is that the <br /> interceptor may not be required for this project; however, Industrial Pretreatment will <br /> make final determination. Please contact IPT directly at (425) 257-8240. <br /> Prior to the issuance of the plumbing permit, a commercial kitchen-plumbing permit will <br /> be required. Please see the attached checklist for submission requirements (IPT handout <br /> is on the back). <br /> 1 <br /> „„„4:--The calculated occupant load is greater than 50 persons, which would require the space <br /> to be classified as an assembly occupancy. When we employ the provisions of Section <br /> 1004.1.2 to permit a stated occupant load less than 50, we require the following: <br /> a. The maximum occupant load should be posted. The location and wording of the <br /> sign should be shown on the plans. <br /> i <br /> f <br /> 1 <br />