2900 GRAND AVE CHOUX CHOUX BAKERY 2018-09-11

Lighting, Motor, and Tr sformer Permit Document •,hecklist LTG-CHK 2012 Washington State Energy Code Compliance Forms for ommercial Buildings including R2&R3 over 3 stories and all R1 Revised Jan 2014 Project Address CHOUX CHOUX BAKERY Date 5/6/2015 The following information is necessary to check a permit application for compliance with the lighting,motor,and transformer requirements in the Washington State Energy Code,Commercial Provisions. Applicability Location in Building Department (yes,no,na) Code Section Component Compliance information required in permit documents Documents Notes LIGHTING CONTROLS(Section C405.2) Indicate on plans the manual control type&locations served; C405.2.1.1 Manual interior Yea Indicate of plans the 50%lighting load reduction method C405.2.1.2 lighting controls provided or identify exception taken Indicate lighting system automatic shut-off capability-identify lighting zone areas served on plans; Automatic time Indicate locations of override switches on plans and the areas Yes C405.2.2.1 switch controls and served,include area sq.ft.; override switching Indicate locations where automatic shutoff is provided by other methods(occupancy sensor,daylight controls,etc) Yes C405.2.2.2 Occupancy sensors Indicate on plans the locations served by occupancy sensors Daylight zones- Indicate vertical fenestration primary and secondary daylight Yes C405.2.2.3 Vertical fenestration zone areas on plans,include sq.ft.; and skylights Indicate skylight daylight zone areas on plans,include sq.ft. Indicate on plans the locations served by daylight zone Daylight zone controls; Yes C405.2.2.3.2 controls Indicate in plans the lighting load reduction(dimming)method- stepped or continuous dimming Specific application Indicate on plans the locations served by specific application Yes C405.2.3 lighting controls- General lighting controls Indicate lighting control method for display and accent lighting, and display case lighting; C405.2.3- Display and accent Yes Items 1&2 lighting Indicate these fixtures are controlled independently from both general area lighting and other lighting applications within the same space Provide a lighting control device at each guest room entry for C405.2.3- Hotel/motel guest all permanently installed fixtures in guest room; NA Item 3 rooms Indicated whether lighting control is manual or automatic C405.2.3- Supplemental task Provide automatic shut-off vacancy controls for supplemental Yes Item 4 lighting task lighting,including under-shelf or under-cabinet lighting Identify eligible non-visual applications and method of lighting control; C405.2.3- Lighting for non- NA Item 5 visual applications Indicate these fixtures are controlled independently from both general area lighting and other lighting applications within the same space Indicate lighting control method for lighting equipment for sale Lighting equipment or demonstration; C405.2.3- Yes for sale or Indicate these fixtures are controlled independently from both Item 6 demonstration general area lighting and other lighting applications within the same space If egress lighting power density is greater than 0.05W/ft2, indicate method of automatic shut-off during unoccupied C405.2.3- Means of egress Yes periods; Item 7 lighting Identify on plans the egress fixtures that function as both normal and emergency means of egress illumination Provide vacancy device or timer to turn off fixtures within 15 C405.10 Cooler and freezer Yes minutes of unoccupancy for cooler and freezer lighting fixtures C405.11 lighting with lamp efficacy less than 40 lumens per watt Exterior lighting Indicate on exterior lighting plans the automatic lighting control NA C405.2.4 controls method and locations served Exterior building Provide motion sensor controls for building grounds fixtures NA C405.6.1 grounds lighting rated at greater than 100 watts with lamp efficacy less than 60 controls lumens,or identify exception taken Identify applicable commissioning documentation requirements per Section C408 or eligibility for exception; Provide written procedures for functional testing of all Lighting system Yea C408.3 automatic controls and describe the expected system functional testing response; Identify in construction documents the party responsible for functional testing of automatic lighting controls a INTERIOR LIGHTING POWER&EFFICACY(Sections C405.5,C405.10,C405.11) ( U