McCann Construction Enterprises Inc 11/7/2018

I 1 2 j. The Bidder fails to submit an Underutilized Disadvantaged Business Enterprise I 3 Broker Agreement, if applicable, as required in Section 1-02.6, or if the 4 documentation that is submitted fails to demonstrate that the fee/commission is 5 reasonable as determined by the Contracting Agency; or 6 1 7 k. The Bid Proposal does not constitute a definite and unqualified offer to meet the 8 material terms of the Bid invitation. 9 I 10 1-03.AP1 11 Section 1-03, Award and Execution of Contract 12 January 2, 2018 I13 1-03.3 Execution of Contract 14 The first paragraph is revised to read: I 15 16 Within 20 calendar days after the Award date, the successful Bidder shall return the 17 signed Contracting Agency-prepared Contract, an insurance certification as required by I 18 Section 1-07.18, a satisfactory bond as required by law and Section 1-03.4, the Transfer 19 of Coverage form for the Construction Stormwater General Permit with sections I, Ill, and 20 VIII completed when provided, and shall be registered as a contractor in the state of I 21 Washington. 22 23 1-03.5 Failure to Execute Contract I 24 The first sentence is revised to read: 25 26 Failure to return the insurance certification and bond with the signed Contract as required 27 in Section 1-03.3, or failure to provide Disadvantaged, Minority or Women's Business 28 Enterprise information if required in the Contract, or failure or refusal to sign the Contract, 29 or failure to register as a contractor in the state of Washington, or failure to return the 30 completed Transfer of Coverage for the Construction Stormwater General Permit to the I 31 Contracting Agency when provided shall result in forfeiture of the proposal bond or 32 deposit of this Bidder. 33 I 34 1-05.AP1 35 Section 1-05, Control of Work 36 August 6, 2018 I37 1-05.5 Vacant 38 This section, including title, is revised to read: I 39 40 1-05.5 Tolerances 41 Geometrical tolerances shall be measured from the points, lines, and surfaces defined in I 42 Contract documents. 43 44 A plus (+) tolerance increases the amount or dimension to which it applies, or raises a 45 deviation from level. A minus (-) tolerance decreases the amount or dimension to which I46 it applies, or lowers a deviation from level. Where only one signed tolerance is specified 47 (+ or-), there is no specified tolerance in the opposing direction. 48 I I