2320 CALIFORNIA ST BASE FILE 2019-01-24

Interior Lighting - Space-By-Space Method LTG-INT-SPACE 2015 Washington State Energy Code Compliance Forms for Commercial Buildings including R2,R3,R4 over 3 stories and all R1 Revised July 2016 Project Title: Fill this line out on LGT-SUM Date 7/1/2016 Calculation Q Q Addition- Q Addition For Building Department Use Area NOTE s stand alone +existing 0 Spaces where<50Tof Spaces where°50%of luminaires are replaced luminaires are replaced LPA ® Standard 0 Additional Efficiency Package Option 0 Calculation C406.3 Reduced Interior Lighting To comply with C406.3,the Proposed LPD shall be 25%lower than the Target LPA. Type Refer to C406.3 for additional requirements. Maximum Allowed Lighting Wattage NOTE 1 Location(plan#, Ceiling Gross Interior Allowed Watts Allowed room#) Space Type Height NOTE 2 Area in ft2 Watts per ft2 (watts/ft2 x area) OFFICE 322 Office:Enclosed 180 0.890 160 OFFICE 314 Office:Enclosed 230 0.890 205 • OFFICE 318 Office:Enclosed 154 0.890 137 CONF RM 315 Conference/meeting/multipurpose 156 0.980 153 OPEN OFFICE Office:Open plan 480 0.780 374 330 OFFICE 321 Office:Enclosed 168 0.890 150 Total Area 1368 Retail Display Allowance from LTG-INT-DISPLAY Lobby Art/Exhibit Display Allowance from LTG-INT-DISPLAY NOTES Allowed Watts 1179 Proposed Lighting Wattage NOTE a Location(plan#, Number of Watts/ ,`f� # Watts room#) Fixture Description NOTE 4,5,6 Fixtures Fixture NOTE 7 "4,1r.::744e4rtec Proposed OFFICE 322 TYPE A2 2 60t 120 OFFICE 314 TYPE A2 3 60i' 180 OFFICE 318 TYPE A2 2 60 'It i 120 -t44.*;*.W.1 CONF RM 315 TYPE A2 2 604410,r WV 120 j.OPEN OFFICE TYPE Al 14 30 r , s0 420 OFFICE 321 TYPE A2 2 60 ,_T " .{ ti 120 Proposed Retail Display Lighting from LTG-INT-DISPLAY Total Proposed Watts may not exceed Total Allowed Watts for Interior Lighting Total Proposed Watts 1080 Interior Lighting Power Allowance COMPLIES Note 1-List all unique space types per Table C405.4.2(2)that occur in the project scope.Select space type category per from drop down menu. Note 2-Indicate ceiling height for atriums and spaces utilizing the ceiling height adjustment per Table C405.4.2(2),Footnotes d thru f. Note 3-List all proposed lighting fixtures including exempt lighting equipment and existing-to-remain fixtures. Note 4-For proposed Fixture Description,indicate fixture type,lamp type(e.g. T-8),number of lamps in the fixture,and ballast type(if included).For track lighting,list the length of the track(in feet)in addition to the fixture,lamp,and ballast information. Note 5-For lighting equipment eligible for exemption per C405.4.1,note exception number and leave Watts/Fixture blank. Note 6-Existing-to-remain fixtures shall be included in the Proposed Lighting Wattage table in the same manner as new fixtures.Identify as existing in fixture description. Note 7-For proposed Watts/Fixture enter the luminaire wattage for installed lamp and ballast using manufacturer or other approved source.For luminaires with screw-in lamps,enter the manufacturer's listed maximum input wattage of the fixture(not the lamp wattage).For low voltage lighting,enter the wattage of the transformer.For line voltage track/busway systems,enter the larger of the attached luminaire wattage or 50 watts/lineal foot,or enter the wattage limit of permanent current limiting device. Note 8-Lobby Art/Exhibit Display Allowance is independent of the Maximum Allowed Lighting Wattage. Note 9-Calculation Area Details: a Lighting fixtures in a building addition may comply as a stand alone project,or they may be combined with the overall existing building liohtino systems to demonstrate compliance.Refer to C502.1. j