607 SE EVERETT MALL WAY NORTH CORNER STUDIOS 2019-01-28

' Interior Lighting - Building Area Method LTG-INT-BLD 2015 Washington State Energy Code Compliance Forms for Commercial Buildings including R2,R3,R4 over 3 stories and all R1 Revised August 2016 Project Title: NORTHCORNER STUDIOS(FITNESS CENTER) Date 8.29.17 Calculation CAddition- ( Addition For Building Department Use Area NOTE s stand alone +existing Spaces where<50%of r'1Spaces where>_50%of uminaires are replaced luminaires are replaced LPA CStandard CAdditional Efficiency Package Option Calculation C406.3 Reduced Interior Lighting Power J To comply with C406.3,the Proposed LPD shall be 25%lower than the Target LPA. Type Refer to C406.3 for additional requirements. Maximum Allowed Lighting Wattage NOTE 1 I Location(plan#, Gross Interior Allowed Watts Allowed Building Area - room#,or ALL) Area Description Area in ft2 Watts per ft2 (watts/ft2 x area) Office office and childrens playroom 333 0.66 Unlit Exercise center 168 0.67 Unlit 742 Unlit 576 Unlit Total 1819 Proposed Lighting Wattage Location(plan#, Number of vvaus per Building Area room#) Fixture Description NOTE 2,3,4,5 Fixtures Fixture NOTE 6 Watts Proposed Compliance by Building Area NOTE 7 Total Allowed Total Proposed Interior Lighting Building Area Warnings Watts Watts Power Allowance Office Confirm all fixtures are reported under proposed lighting-low watts relative UNLIT to maximum allowed. Exercise center Confirm all fixtures are reported under proposed lighting-low watts relative UNLIT to maximum allowed. Note 1-List all unique building areas per Table C405.4.2(1)that occur in the Totals project scope. Select building area category from drop down menu. Note 2-Proposed fixtures must be listed in the building area in which they occur.List all proposed lighting fixtures including exempt lighting equipment and existing-to-remain fixtures. Note 3-For proposed Fixture Description,indicate fixture type,lamp type(e.g. T-8),number of lamps in the fixture,and ballast type(if included). For track lighting,list the length of the track(in feet)in addition to the fixture,lamp,and ballast information. Note 4-For lighting equipment eligible for exemption per C405.4.1,note exception number and leave Watts/Fixture blank. Note 5-Existing-to-remain fixtures shall be included in the Proposed Lighting Wattage table in the same manner as new fixtures. Identify as existing in fixture description. Note 6-For proposed Watts/Fixture enter the luminaire wattage for installed lamp and ballast using manufacturer or other approved source.For luminaires with screw-in lamps,enter the manufacturer's listed maximum input wattage of the fixture(not the lamp wattage).For low voltage lighting,enter the wattage of the transformer.For line voltage track/busway systems,enter the larger of the attached luminaire wattage or /' 50 watts/lineal foot,or enter the wattage limit of permanent current limiting device. Note 7-Prnnosed Wattage for each Buildina Area tvne shall not exceed the Allowed Wattaae for that Buildina Area tvne Tradina wattaae l