Laserfiche WebLink
• • Chapter 3—System Design <br /> • .4312-.34g <br /> REV.2 <br /> PCI-70ABC with 3 nozzles <br /> elCYLINDER <br /> a <br /> Ti y T2 <br /> a a NOZZLE <br /> 002867PC <br /> ► Maximum Length Elbows <br /> Cylinder Size Nozzle Quantity Nozzle Type Piping Section Size Maximum Maximum <br /> PCI-70ABC 3 NV-WA or NV-SW Cylinder to T1 1 in. 40 ft. (12.2 m) 4 <br /> T1 to T2 3/4 in. 18 ft. (5.5 m) 2 <br /> T1 to Nozzle 3/4 in. 18 ft. (5.5 m) 2 <br /> T2 to Nozzle 3/4 in. 9 ft. (2.7 m) 2 <br /> NOTE: <br /> 1.These limitations apply to PCI-70ABC using three NV-WA or NV-SW nozzles. <br /> 2. For systems that have been tested with unbalanced piping, the difference in the length of piping must not exceed 10% of <br /> the maximum unbalanced ratio tested. <br /> 3. A Main/Reserve Swing Check Valve, Part No.417788, may be located between the cylinder and Ti. <br /> 4. All systems protecting vehicle paint spray booths require a factory pre-set time delay. <br /> ► 5. Maximum height of nozzle from base of tank to nozzle—20 ft. (6.1 m). <br /> V/IN,66-01 <br /> ULEX 3437 CEx732 <br /> September 1,2006 <br />