Laserfiche WebLink
4 <br /> h / <br /> Exterior Lighting LTG-EXT <br /> 2015 Washington State Energy Code Compliance Forms for Commercial Buildings including R2,R3,R4 over 3 stories and all R1 Revised August 2016 <br /> Project Title: KFC E080013 7407 Evergreen Way,Everett WA 98203 Date 4/6/2017 <br /> Exterior Lighting Zone 1 Zone 2 Zone 3 0Zone 4 For Building Department Use <br /> Zone Table C405.5.2(1) <br /> Specified by jurisdiction. Zone selection required to enable LTG-EXT form <br /> Calculation Area 0 O Addition- 0 Addition <br /> stand alone +existing <br /> (-1 Alteration with<50% Alteration with a 50%ext. <br /> ext.wattage replaced wattage replaced <br /> Building Grounds 0 Efficacy>80 lumens/watt ©Exemption <br /> Applies to luminaires> <br /> 100 Watts Li Controlled by motion sensor <br /> Tradable Maximum Allowed Lighting Wattage NOTE I Base Site Allowance: 600 <br /> Area(ft`),perimeter(If) Allowed Watts Allowed Watts <br /> Tradable Surfaces Surface Description or#of items per ft2 or per If x ft2(or x If) <br /> Other Entry Door Back Door 3 20W/LF door 60 <br /> Total Allowed Tradable+Site Allowance Watts: 660 <br /> Tradable Proposed Lighting Wattage NOTE 2 <br /> Number of Watts per Watts <br /> Tradable Surface Fixture Description NOTE 3,a Fixtures Fixture NOTE 5 Proposed <br /> Other Entry Door LED 1;M-3 LED Wallpack,1 Lamp 1 20 20 <br /> Total proposed tradable watts may not exceed the sum of total allowed tradable Total Proposed Tradable Watts: 20 <br /> watts plus the base site allowance. Any base site allowance not needed to make <br /> tradable watts comply can be applied to individual non-tradable categories. <br /> Non-Tradable Maximum Allowed Lighting Wattage""'E' Site Allowance Remaining: 600 <br /> Area(ft2),perimeter(If) Allowed Watts Allowed Watts <br /> Non-Tradable Surfaces Surface Description or#of items per ft2 or per If x ft2(or x If) <br /> Bldg.Facade Graphics 234 0.1 W/ft2 24 <br /> Bldg.Facade Signage 12 0.1 W/ft2 2 <br /> Non-Tradable Proposed Lighting Wattage NOTE 2 <br /> Number of Watts per Watts <br /> Non-Tradable Surface Fixture Description NOTE a,a Fixtures Fixture NOTE 5 Proposed <br /> Bldg.Facade LED 2;E-1 LED Flood Light,1 Lamp 13 24 312 <br /> Bldg.Facade LED 3;E-2 LED Flood Light,1 Lamp 3 31 93 <br /> Non-tradable proposed watts may not exceed allowed watts for any individual Non-Tradable Watts Exceeding LPA: 379 <br /> surface unless the total excess watts for all non-tradable surfaces are less than the <br /> remaining site allowance. Remaining Site Allowance: 221 <br /> Exterior Lighting COMPLIES WITH MAX. ALLOWANCE <br /> Note 1-List all unique exterior sufaces per Table C405.5.2(2)that occur in the project scope.Select exterior surface categories from drop <br /> down menu. <br /> Note 2-List all proposed lighting fixtures including existing-to-remain fixtures. <br /> Note 3-For proposed Fixture Description,indicate fixture type,lamp type,number of lamps in the fixture,and ballast type(if applicable). <br /> Note 4-Existing-to-remain fixtures shall be included in the Tradable and Non-Tradable Proposed Lighting Wattage tables in the same manner <br /> as new fixtures.Identify as existing in fixture description. <br /> Note 5-For proposed Watts/Fixture enter the luminaire wattage for installed lamp and ballast using manufacturer or other approved source.For <br /> luminaires with screw-in lamps,enter the manufacturer's listed maximum input wattage of the fixture(not the lamp wattage).For low - <br /> voltage lighting,enter the wattage of the transformer. °' <br /> i : <br /> I <br />