3927 RUCKER AVE 2ND FLOOR 2019-04-17

Lighting, Motor, and E.ectrical Permit Checklist, Pg. 3 LTG-CHK 2015 Washington State Energy Code Compliance Forms for Commercial Buildings including R2,R3,R4 over 3 stories and all R1 Revised Nov 2017 The Everett Clinic-Hand Therapy Remodel Date 8/30/2018 The following information is necessary to check a permit application for compliance with the lighting,motor,and electrical requirements in the Applicability Location in Building Department (yes,no,na) Code Section Component Compliance information required in permit documents Documents Notes MOTORS,TRANSFORMERS, ELECTRIC METERS, INTERIOR TRANSPORTATION NA C405.6 Electrical Include electrical transformer schedule on electrical plans; transformers indicate transformer size,efficiency,or exception taken Dwelling unit Indicate on electrical plans that each dwelling unit in Group R-2 NA C405.7 electrical energy has a separate electrical energy meter consumption Electric motor Include all motors,including fractional hp motors,in electric NA C405.8 efficiency motor schedule on electrical plans;indicate hp,rpm,rated efficiency,or exception applied For luminaires in each elevator cab,provide calculated average efficacy of combined fixtures that indicates efficacy is not less than 35 lumens per watt; NA C405.9.1 Elevator cabs Indicate rated watts per cfm for elevator cab ventilation fans do not exceed 0.33 watts per cfm; Indicate automatic controls that de-energize lighting and ventilation fans when elevator is stopped and unoccupied for a period of 15 minutes or more Escalators and Indicate escalators comply with ASME A17.1/CSA B44; NA C405.9.2 moving walks automatic controls are configured to reduce operational speed to the minimum permitted when not in use NA C405.9.3 Regenerative drive Indicate all one-way down or reversible escalators are provided with a variable frequency regenerative drive DOCUMENTATION AND SYSTEM REQUIREMENTS TO SUPPORT COMMISSIONING(Cx) Indicate that all electrical systems(receptacles,transformers, motors,vertical and horizontal transportation)for which the WSEC requires control functions and/or configuration to Scope of electrical perform specific functions are required to be commissioned; power and lighting NA C408.3 Where total building lighting load is>20 kW,or where total systems commissioning lighting load of luminaires requiring daylight sensing and/or occupancy control>10 kW,indicate that all automatic lighting control systems are required to be commissioned;or provide building lighting power calculation demonstrating eligibility for exception; Indicate Cx requirements in plans and specifications for all applicable electrical and lighting control systems per C408; Include general summary with at minimum Items 1 thru 4 of the C405.13 Cx plan per C408.1.2 including:narrative description of C408.1.1 Commissioning activities,responsibilities of the Cx team,schedule of activities NA C408.1.2 requirements in including verification of project close out documentation per C408.1.4.2 construction C103.6,and conflict of interest plan(if required); C103.6 documents Include in general summary that a Cx project report or Compliance Checklist(Figure C408.1.4.2)shall be completed by the Certified Cx Professional and provided to the owner prior to the final electrical inspection Functional Identify in plans and specifications the intended operation of all NA C408.3.1 performance testing equipment and controls during all modes of operation,including criteria interfacing between new and existing-to-remain systems PROJECT CLOSE OUT DOCUMENTATION Indicate in plans that project close out documentation is Project close out required including WSEC lighting compliance forms and NA C103.6.3 documentation calculations that document all interior and exterior lighting area requirements and/or surface types,lighting power allowances and installed densities If"no"is selected for any question, provide explanation: 67/L: