Rodarte Construction 4/29/2019 - Laserfiche WebLink

I CITY OF EVERE T T SPECIAL PROVISIONS in the offer. If the City approves the substitution, the Contract Documents will be modified by a Change Order modifying the Contract Sum in the amount of the cost differential. 1-06.2 Acceptance of Materials 1-06.2(2)B Financial Incentive Delete 1-06.2(2)B. 1-06.2(2)D Quality Level Analysis ' Delete 1-06.2(2)D. 1-06.3 Manufacturer's Certificate of Compliance ' Supplement 1-06.3 by adding the following: When authorized by the Standard Specifications or these Special Provisions and prior to use, the Engineer may accept certain Equipment on the basis of a Manufacturer's Certificate of Compliance as an alternate to Equipment inspection and testing. A Manufacturer's Certificate of Compliance shall be reserved for cases where compliance to Contract requirements is not readily determinable through inspection and testing of materials or Equipment. The Contractor shall provide properly authenticated documents to the City's Representative that the materials and Equipment comply with the Contract requirements. The Contractor shall pay all associated costs of providing each Manufacturer's Certificate of Compliance submitted for City acceptance. The City reserves the right to refuse to accept Equipment on the basis of a ' Manufacturer's Certificate of Compliance. 1-06.3(1) Inspection at Point of Manufacturing (******) The Contractor shall be responsible to reimburse the City for the costs of inspections at the point of manufacturing for inspections occurring outside of Whatcom, Skagit, Island, Snohomish, King, Pierce and Thurston counties. Costs to be paid or reimbursed by the Contractor include, but are not limited to, travel, subsistence, labor and lodging expenses of the City Inspector. Point of manufacturing inspection will be required if: Inspection and testing of materials or Equipment in the vicinity of the Work by the ' City is not practicable, The Contractor requests the City to inspect and test material or Equipment at the point of manufacture, or ' The Standard Specifications or these Special Provisions require that inspection, testing or witnessing of tests take place at the point of manufacture. 1-06.4 Handling and Storing Materials Supplement 1-06.4 by adding the following: Contractor shall store materials and Equipment so as to insure the preservation of their quality and fitness for the Work. Store Equipment and materials at location that facilitates inspection. The Contractor shall be responsible for damages, loss or casualty occurring to materials and Equipment until Final Acceptance. 1 Alverson Stormwater Separation February, 2019 WO No—UP3660 Division 1 —GENERAL REQUIREMENTS SP—73 I