Laserfiche WebLink
EXHIBIT 1 TO ORDINANCE <br /> may be used if it is detailed with masonry, metal or other appropriate materials on the <br /> same wall surface; and high quality fiber cement panel systems may be used, such as <br /> Hardie board, for horizontal siding up to an exposure maximum of eight inches and <br /> with appropriate architectural detailing to add visual interest. <br /> f. Common open space, parks and public recreational facilities may be counted towards <br /> one-half the on-site open space requirements for a residential use (other than single <br /> family detached), if such areas are located within 1,000 feet of the residential use. <br /> g. The Special Regulations in Table 5.1 in EMC 19.5 are not applicable. <br /> 3. Basic Standards/Single Family Detached Residential. Single family detached residential <br /> development will be subject to the following code development standards: <br /> a. Cottage housing is permitted. <br /> b. The following table includes the basic development standards that supersede <br /> inconsistent standards of the Everett Municipal Code: <br /> Single Family Detached(3) <br /> Ianlll\ _AIIIo,ullit(2It`) ( t 11,1.1.• <br /> Alley oai)ed O <br /> from street(4) <br /> \linLotArea 3000 2400 3000 <br /> Min Req'd Setbacks: <br /> Front 10' 10' 10' <br /> Front w/Garage Entrance 18' N/A N/A <br /> Rear 10' 10'(1) 10' <br /> Side Street 10' 10' 10' <br /> Side Interior5' 5'(1) 5' <br /> Min Lot Width 50' 40' 50' <br /> Min Lot Depth 60' 60' 60' <br /> Max Bldg Height per site per site per site <br /> Max Resid Density(u/acre) None None None <br /> Min Landscaped Area 15% 15% 15% <br /> 0 en S.ace on Site(5) 15x15=225sf 15x15=225sf 15x15=225sf * <br /> *Refer to 33G.100 Cottage Housing in the Everett Core Residential Development and Design Standards <br /> (1) No rear setback is required for garages on an f) Garages may be attached in any setback between <br /> alley/lane,including livable space above the garage. the autocourt lots.If they are not attached,a <br /> Where garages on alleys/lanes are attached,no side minimum 5 foot setback is required for garages(10 <br /> yard setback is required. foot building separation). <br /> (2) Standards for Autocourts (3) The main entrance must be covered and a minimum of <br /> 36 square feet with a minimum dimension of 4'.This <br /> a)Autocourts may include up to 4 units,with two can be a porch,stoop or inset as long as at least two <br /> units fronting on the street space,and two units sides are open.The main entrance will also face/be <br /> behind.There may be open space between the front oriented towards the street and/or open space. <br /> lots and the street. (4) Driveway for vehicles will be a maximum of 20 feet <br /> b)All vehicular access must be taken from the access wide. <br /> drive. (5) 225 square feet of open/private space on each lot with <br /> c)Garages for the front units must be located on the a maximum dimension of 15 feet by 15 feet is required <br /> back of the front lot and no parking in the front and cannot be reduced in size. <br /> yard. <br /> d)The primary residential entrances for the front lots <br /> must be oriented to the street. <br /> e)The access drive must include a maximum of 20 <br /> feet wide paving with five foot setbacks between <br /> the paving/curb and the units. <br /> F - 10 <br /> FINAL ATT F.DOC <br /> 10/21/2008 <br />