5901 HIGHWAY PL WHOLE SITE 2019-06-04

SPECIFICATIONS CONT.) • • Install with the long dimension or strength axis of the panel WALL INSTALLATION across supports and with the panel continuous over two or more spans. • Provide 1/8 in.space at panel ends and edges.Use a spacer tool • LP FlameBlock Fire-Rated OSB Sheathing panels may be (i.e.10d box nail)to ensure accurate and consistent spacing. installed vertically or horizontally.In horizontal installations, stagger joints a minimum of one stud space. • Panel end joints shall occur over framing.Stagger end joints in each succeeding row. • When installing LP FlameBlock Fire-Rated OSB Sheathing in walls,consult approved construction plans to determine the • For panels in the 7/16 and 15/32 category and thinner,provide proper orientation of the white,fire-resistant panel surface. additional panel stiffness by installing panel edge clips mid-span on all un-supported edges. • Provide 1/8 in.space between panel ends and edges.Use a spacer tool(i.e.10d box nail)to ensure accurate and consistent • Nail 6 in.o.c.along supported panel ends and edges and 12 in. spacing. o.c.at intermediate supports.Fasten panels 3/8 in.from panel edges.Use 8d common nails for panels up to 1 in.thickness.For • At minimum,nail 6 in.o.c.along supported panel ends and panels over 1 in.use 8d ring-shank or 10d common nails.Other edges and 12 in.o.c.at intermediate supports.Fasten panels code-approved fasteners may be used. 3/8 in.from panel edges.Use 6d common nails for panels up to 1 in.thickness.For panels over 1 in.use 8d ring-shank or 8d • Cover roof sheathing as soon as possible with roofing felt or common nails.Other code-approved fasteners may be used.For shingle underlayment for protection against excessive moisture additional fastening requirements,refer to Figure 3,NOTE:For prior to roofing.If any edge swelling occurs prior to roof underlay- sheer walls,use the fastener spacing specified in approved con- ment installation,the exposed wood substrate side of panels struction documents. with raised joints should besanded flat. • Remove wrinkles and flatten surface of shingle underlayment before installing shingles.High performance shingle underlay- ment is recommended for better results. • Heavier weight and/or textured shingles are recommended to better mask imperfections in roofing assembly. • When installed as roof deck in open eaves,the exposed under- side of panels,as well as any exposed edges,must be coated with exterior-grade paint. NOTE:Check with your local building department before deciding on an installation method. LP° FlameBlock® Fire-Rated Sheathing PRODUCT DSCRIPTION • Structural performance is verified by Progressive Engineering,Inc.(Report,PER-06013),www.p-e-i.com. LP FlameBlock Fire-Rated OSB Sheathing panels are designed for use in roof,wall and subfloor systems in commercial and residential Fire performance is verified by Omega Point/Intertel<(listing projects,maintenance,remodeling or new construction. 1532-4).Directory can be referenced at www.opl.com. STANDARDS & CERTIFICATIONS LP FlameBlock Fire-Rated OSB Sheathing panels comply with the following industry standards and certifications: • LP FlameBlock Fire-Rated OSB Sheathing panels are certified to comply with U.S.Voluntary Product Standard PS2,which is recog- nized in the Uniform Building Code,the International-Building Code and the International Residential Code,and by International Code Council Evaluation service(ICC-ES)Evaluation Report ESR-1365.