1305 14TH ST 2019-06-05 - Laserfiche WebLink

INSTALLATION The damper clamp with hex bolt (Fig. 11-1) is provided as a means to �` prevent full closure of the damper blade.The clamp is easily attached to most damper blades with pliers or a wrench, and must be permanently installed.The clamp is designed to prevent accidental closure of the damper C when installed as illustrated(Fig.11-2 and Fig.11-3).Should the clamp not fit, or fail to provide the permanent vent opening listed in the table found above,have a permanent stop installed,remove the damper blade, or have the damper cut to provide Seik t screw = Wm + the minimum permanent opening required. \ 41KiN\ mu NM Note: These are minimum damper opening *2 MIN c 11 MEI specifications. The damper must beDam er clam completely opened when operating this g pMINI MMIll Open Closed Fig.11-1 Fig.11-2 ,7ccsSFig.11-3 gas appliance to achieve the best ventilation possible. INSTALLING THE BURNER The Real-Fyre gas log set must be installed by a qualified professional service technician. Instructions must be followed carefully to ensure proper performance and full benefit from the gas log set.Check to be sure the log set is designed and labeled for the type of gas(natural or propane gas)supplied to the fireplace. Fireplace floor must be level,clean, and smooth. WARNING: Faureto position the parts in accordance with these diagrams or failure to use onlyparts, specifically approved with this appliance may result in property damage or personal injury. REFER TO THE PARTS LIST WHEN FOLLOWING THESE INSTRUCTIONS. 1. MAKE SURE THE FIREPLACE GAS SUPPLY IS TURNED OFF. 2. Locate the gas-supply stub inside the fireplace and remove the cap, if attached (see Fig. 11-4 CAUTION: When removing the cap,make sure the stub does not turn,loosening the connection jnside t wall. 3. Attach the nut end of the flex connector to the adapter found on the valve or,if attached,on the reg at- behind the valve.Tighten securely. 0 4. Place the burner system into the fireplace so the open burner pan faces outward. 43, 5. Locate the grate and attach the log locators to the 2 outer bars of the grate with screws and ni. log locators should be loosely positioned toward the middle of the bars with screw slots facing towards fireplace side walls (Fig. 11-5).Temporarily place the front log at the front of the grate, to correctly determine the log locator position. Slide the log locators up against the rear of the front log.Tighten the log locators in place. Remove the front log. 6. Place the grate over the burner pan so the log locator brackets fit over the back edge of the burner pan to lock it in position. 7. Center this assembly in the fireplace and place it as far back in the fireplace as possible.Remove the grate for the gas connection and granule/ember placement. 1 ) Fig. 11-5 Log locators on grate -0 , 77 Gas line cap _ i;� (Brackets are to fit over Gas supply _J ' back edge of burner pan) line slob