Laserfiche WebLink
A 12-inch fiber optic signal section capable of alternately displaying a yellow arrow and a green arrow shall be <br /> furnished and installed where specified in the Plans. <br /> 9-29.16(2) Conventional Traffic Signal Heads <br /> 9-29.16(2)A Optical Units <br /> 9-29.16(2)A <br /> Section 9-29.16(2)A is supplemented with the following: <br /> 9-29.16(2)A LED Signal Displays <br /> All traffic signal displays shall be the Light Emitting Diode (LED) type and shall be from one of the following <br /> manufacturers: <br /> Dialight Corporation <br /> 1913 Atlantic Avenue <br /> Manasquan,NJ 08736 <br /> Telephone: (732) 223-9400 <br /> Fax: (732) 223-8788 <br /> GELcore,LLC <br /> 6810 Halle Drive <br /> Valley View, OH 44125 <br /> Telephone: (216) 606-6555 <br /> Fax: (216) 606-6556 <br /> Precision Solar Controls, Inc. <br /> 2960 Market Street <br /> Garland,TX 75041 <br /> Telephone: (972) 278-0553 <br /> Fax: (972) 271-9583 <br /> Each LED signal module shall be designed to be installed in the door frame of a standard traffic signal housing. <br /> The lamp socket, reflector holder and lens used with an incandescent lamp shall not be used in a signal section in <br /> which a LED signal module is installed. The installation of a LED signal module shall not require any <br /> modification to the housing. The LED signal module shall be a single, self-contained device,not requiring onsite <br /> assembly for installation into an existing traffic signal housing. <br /> All red and yellow LED signal modules shall be manufactured with a matrix of AllnGaP LED light sources and <br /> green LED signal modules shall be manufactured with a matrix of InGaN LED light sources. The LED traffic <br /> signal module shall be operationally compatible with controllers and conflict monitors on this project. The LED <br /> lamp unit shall contain a disconnect that will show an open switch to the conflict monitor when less than 60% of <br /> the LEDs in the unit are operational. <br /> Each LED module shall conform to the current standards in Institute of Transportation Engineers (ITE) VTCSH <br /> Part 2 and a Certificate of Compliance with these standards shall be submitted by the manufacturer for each type <br /> of signal head. The certificate shall state that the lot of signal heads meets the current ITE specification. A label <br /> shall be placed on each LED signal module certifying conformance to this specification. The manufacturer's name, <br /> 55 <br /> Swift II BRT Boeing to Canyon Park Station—Traffic Signal 90%Special Provisions—12/1/2016 <br />