Jansen Inc 6/10/2019 - Laserfiche WebLink

I1 The footnotes are supplemented with the following: 2 I 3 4 across-linking acrylic shall meet the requirements of federal specification TT-P-1952F Section 3.1.1. 5 6 'Cold Flexibility: The paint shall be applied to an aluminum panel at a wet film thickness of I7 15 mils and allowed to dry under ambient conditions (50±10% RH and 72±5 °F) for 24 8 hours. A cylindrical mandrel apparatus (in accordance with ASTM D522 method B) shall be 9 put in a 40°F refrigerator when the paint is drawn down. After 24 hours, the aluminum I10 panel with dry paint shall be put in the 40°F refrigerator with the mandrel apparatus for 2 11 hours. After 2 hours, the panel and test apparatus shall be removed and immediately tested 12 to according to ASTM D522 to evaluate cold flexibility. Paint must show no evidence of I13 cracking, chipping or flaking when bent 180 degrees over a mandrel bar of specified 14 diameter. 15 I 16 6NTPEP test deck, or a test deck conforming to ASTM D713, shall be conducted for a 17 minimum of six months with the following additional requirements: it shall be applied at 15 18 wet mils to a test deck that is located at 40N latitude or higher with at least 10,000 ADT and 111▪ 19 which was applied during the months of September through November. 20 21 'Paint is applied to an approximately 4"x12" aluminum panel using a drawdown bar with a I22 50 mil gap. The coated panel is allowed to dry under ambient conditions (50±10% RH and 23 72±5 °F) for 24 hours. Visual evaluation of the dry film shall reveal no cracks. 24 25 9-34.3 Plastic II26 In the first sentence of the last paragraph, "Federal Standard 595" is revised to read "SAE AMS 27 Standard 595". 28 I29 9-34.3(2) Type B — Pre-Formed Fused Thermoplastic 30 In the last two paragraphs, each reference to "Federal Standard 595" is revised to read "SAE 31 AMS Standard 595". I32 33 9-34.3(4) Type D — Liquid Cold Applied Methyl Methacrylate 34 The Test Method value for Adhesion to PCC or HMA, psi is revised to read "ASTM D45411". 35 36 9-34.4 Glass Beads for Pavement Marking Materials 37 In the Test Method column of the table titled Metal Concentration Limits, "EPA 3052 SW-846 ▪ 38 60100" is revised to read "EPA 3052 SW-846 60100". I 39 40 9-34.5(1) Temporary Pavement Marking Tape — Short Duration ' 41 This section, including title, is revised to read: 42 43 9-34.5(1) Temporary Pavement Marking Tape — Short Duration (Removable) I44 Temporary pavement marking tape for short duration (usage is for up to two months) shall 45 conform to ASTM D4592 Type II except that black tape, black mask tape and the black 46 portion of the contrast removable tape, shall be non-reflective. 47 48 9-34.5(2) Temporary Pavement Marking Tape — Long Duration 49 This section's title is revised to read: • 50 City of Everett Page AM-113 Amendments Everett Downtown Streetscape Improvement March 22, 2019