Laserfiche WebLink
POST-INSTALLED ANCHORS REPORT MAYES TESTING ENGINEERS <br /> Alferracentftomy <br /> Report Number: M7181198.0004 <br /> Service Date: 04/05/18 20225 Cedar Valley Rd Ste 110 <br /> Report Date: 04/23/18 Lynnwood, WA 98036-6365 <br /> 425-742-9360 • <br /> Client Project <br /> Access Laser Company Access Laser Partitions <br /> Attn:John Buskirk 2211 West Casino Dr. Suite A <br /> 917 134th St SW Everett, WA <br /> Everett, WA 98204 <br /> Project No.: M7181198 <br /> Permit No.: B1710-030(Building) Weather: Indoors <br /> Samples: N/A <br /> On site to observe the installation of 1" diameter all-thread rods at column bases noted in report, service date <br /> 03/30/18 (#0002). At (6) column locations the embedment depth of 15" could not be achieved. The contractor <br /> contacted the structural engineer for approval to install at a reduced embedment depth. Per letter from Peter <br /> Kwei, P.E. with KWEI Consulting Engineers, it is acceptable to embed the 1" diameter threaded rods at a depth of <br /> 12". Holes were inspected for size, depth, spacing, clearance and cleanliness, and were cleaned per the <br /> manufacturer's recommendations. The rods were installed using Simpson XP epoxy (expiration 05/17/19). <br /> CORRECTIVE ACTION TAKEN <br /> This report closes preliminary report, service date 03/30/18 (#0002). <br /> To the best of our knowledge, the items inspected today are in conformance with approved plans and <br /> specifications. <br /> Services: Special Inspections/Materials Testing <br /> Mayes/Terracon Rep.: Jacob Keas <br /> Reported to: Western Partitions, Inc. <br /> Contractor: Western Partitions, Inc. <br /> Report Distribution: <br /> (1)Access Laser Company,John (1)Mayes Testing Engineers,Inc, <br /> Buskirk Mike Mattox <br /> (1)United Partition Systems,Inc., Reviewed By: lr,c ''" <br /> Jackie Barboza <br /> Robert Gardner <br /> Senior Project Field Manager <br /> The tests were performed in general accordance with applicable ASTM,AASHTO,or DOT test methods. This report is exclusively for the use of the client <br /> indicated above and shall not be reproduced except in full without the written consent of our company. Test results transmitted herein are only applicable to <br /> the actual samples tested at the location(s)referenced and are not necessarily indicative of the properties of other apparently similar or identical materials. <br /> CT0001,10-16-13,Rev.10 Page 1 of 1 <br />