1505 INDUSTRY ST 2019-07-24 - Laserfiche WebLink

Interior Lighting - Space-By-Space Method LTG-INT-SPACE 2015 Washington State Energy Code Compliance Forms for Commercial Buildings including R2,R3,R4 over 3 stories and all R1 Revised August 2016 Project Title: Garden Fresh Server Room TI Date 2/14/2018 Calculation a a Addition - Addition For Building Department Use Area"T" stand alone +existing Spaces where<50%of d Spaces where z 50%of d luminaires are replaced luminaires are replaced LPA 0 Standard a Additional Efficiency Package Option 4 Calculation C406.3 Reduced Interior Lighting To comply with C406.3,the Proposed LPD shall be 25%lower than the Target LPA. Type Refer to C406.3 for additional requirements. Maximum Allowed Lighting Wattage NOTE' Location(plan#, Ceiling Gross Interior Allowed Watts Allowed room#) Space Type HeightNOTE2 Area in ft2 Watts per ft2 (watts/ft2 x area) Total Area Retail Display Allowance from LTG-INT-DISPLAY Enter Total Existing Lighting Watts(prior to Alteration) Lobby Art/Exhibit Display Allowance from LTG-INT-DISPLAY"orE8 Allowed Watts Proposed Lighting Wattage raTE3 Location(plan#, Number of Watts/ Watts room#) Fixture Description NOTE4,5'a Fixtures Fixture"3TE7 Proposed Proposed Retail Display Lighting from LTG-INT-DISPLAY Total Proposed Watts may not exceed Total Allowed Watts for Interior Lighting Total Proposed Watts Interior Lighting Power Allowance Note 1-List all unique space types per Table C405.4.2(2)that occur in the project scope.Select space type category per from drop down menu. Note 2-Indicate ceiling height for atriums and spaces utilizing the ceiling height adjustment per Table C405.4.2(2),Footnotes d thru f. Note 3-List all proposed lighting fixtures including exempt lighting equipment and existing-to-remain fixtures. Note 4-For proposed Fixture Description,indicate fixture type,lamp type(e.g. T-8),number of lamps in the fixture,and ballast type(if included). For track lighting, list the length of the track(in feet)in addition to the fixture,lamp,and ballast information. Note 5-For lighting equipment eligible for exemption per C405.4.1,note exception number and leave Watts/Fixture blank. Note 6-Existing-to-remain fixtures shall be included in the Proposed Lighting Wattage table in the same manner as new fixtures.Identify as existing in fixture description. Note 7-For proposed Watts/Fixture enter the luminaire wattage for installed lamp and ballast using manufacturer or other approved source.For luminaires with screw-in lamps,enter the manufacturer's listed maximum input wattage of the fixture(not the lamp wattage). For low voltage lighting, enter the wattage of the transformer.For line voltage track/busway systems,enter the larger of the attached luminaire wattage or 50 watts/lineal foot,or enter the wattage limit of permanent current limiting device. Note 8-Lobby Art/Exhibit Display Allowance is independent of the Maximum Allowed Lighting Wattage. Note 9-Calculation Area Details: a.Lighting fixtures in a building addition may comply as a stand alone project,or they may be combined with the overall existing building lighting systems to demonstrate compliance.Refer to C502.1. 3