Laserfiche WebLink
I <br /> 1 9-29.2(2)A Standard Duty Cable Vaults and Pull Boxes <br /> 2 In the table in the last paragraph, the fourth, fifth and sixth rows are revised to read: <br /> 3 <br /> Slip Resistant Lid ASTM A36 steel <br /> Frame ASTM A36 steel <br /> Slip Resistant Frame ASTM A36 steel <br /> 4 <br /> 5 9-29.3(2)A1 Single Conductor Current Carrying <br /> 6 This second sentence is revised to read: <br /> 7 <br /> 8 Insulation shall be XLP (cross-linked polyethylene) or EPR (Ethylene Propylene Rubber), <br /> 9 Type USE (Underground Service Entrance) or USE-2, and rated for 600-volts or higher. <br /> 10 <br /> 11 9-29.6 Light and Signal Standards <br /> 12 In the first sentence of the third paragraph, "AASHTO M232" is revised to read "ASTM F 2329". <br /> 13 <br /> 14 Item number 2 of the last paragraph is revised to read: <br /> 15 <br /> 16 2. The steel light and signal standard fabricator's shop drawing submittal, including <br /> 17 supporting design calculations, submitted as a Type 2E Working Drawing in <br /> 18 accordance with Section 8-20.2(1) and the Special Provisions. <br /> 9 <br /> 2 <br /> 20 9-29.6(1) Steel Light and Signal Standards <br /> 21 In the second paragraph, "AASHTO M232" is revised to read "ASTM F 2329". <br /> 22 <br /> 23 The first sentence of the last paragraph is revised to read: ' <br /> 24 <br /> 25 Steel used for light and signal standards shall have a controlled silicon content of either <br /> 26 0.00 to 0.06 percent or 0.15 to 0.25 percent. <br /> 27 <br /> 28 9-29.6(5) Foundation Hardware <br /> 29 In the last paragraph, "AASHTO M232" is revised to read "ASTM F 2329". <br /> 30 <br /> 31 9-29.10(1) Conventional Roadway Luminaires <br /> 32 This section is revised to read: <br /> 33 <br /> 111 <br /> 34 All conventional roadway luminaires shall meet 3G vibration requirements as described in <br /> 35 ANSI C136.31. <br /> 36 <br /> 37 All luminaires shall have housings fabricated from aluminum. The housing shall be painted <br /> 38 flat gray, SAE AMS Standard 595 color chip No. 26280, unless otherwise specified in the <br /> 39 Contract. Painted housings shall withstand a 1,000 hour salt spray test as specified in <br /> 40 ASTM B117. <br /> 41 <br /> 42 Each housing shall include a four bolt slip-fitter mount capable of accepting a nominal 2" <br /> 43 tenon and adjustable within +1- 5 degrees of the axis of the tenon. The clamping bracket(s) <br /> 44 and the cap screws shall not bottom out on the housing bosses when adjusted within the <br /> 45 +1- 5 degree range. No part of the slipfitter mounting brackets on the luminaires shall <br /> 46 develop a permanent set in excess of 0.2 inch when the cap screws used for mounting are , <br /> City of Everett Page AM-136 Amendments <br /> Everett Station 80 Stall Parking Expansion June 2019 <br />