Kamins Construction Inc Pacific Ave to Interurban Trail Bicycle Safety

I 1 environmental conditions under which the paint can be applied. Application of paint under 2 environmental conditions other than those specified in this section will not be allowed 3 without the Engineer's concurrence. 4 I 5 6 6-07.3(9)F Shop Surface Cleaning and Preparation 7 The last sentence is revised to read: I 8 9 The entire steel surface to be painted, including surfaces specified in Section 6-07.3(9)G 10 to receive a mist coat of primer, shall be cleaned to a near white condition in accordance 11 with SSPC-SP 10, Near-white Metal Blast Cleaning, and shall be in this condition 12 immediately prior to paint application. 13 14 6-07.3(9)G Application of Shop Primer Coat I 15 The first paragraph is supplemented with the following: 16 17 Repairs of the shop primer coat shall be prepared in accordance with the painting plan. I 18 19 Shop primer coat repair paint shall be selected from the approved component based or performance based paint system in accordance with Section 6-07.3(10)H. 20 I 21 6-07.3(9)H Containment for Field Coating 22 This section is revised to read: 23 24 The Contractor shall use a containment system in accordance with Section 6-07.3(10)A 25 for surface preparation and prime coating of all uncoated areas remaining, including bolts, 26 nuts, washers, and splice plates. 27 I 28 During painting operations of the intermediate, stripe and top coats the Contractor shall 29 furnish, install, and maintain drip tarps below the areas to be painted to contain all spilled 30 paint, buckets, brushes, and other deleterious material, and prevent such materials from I 31 reaching the environment below or adjacent to the structure being painted. Drip tarps shall 32 be absorbent material and hung to minimize puddling. The Contractor shall evaluate the 33 project-specific conditions to determine the specific type and extent of containment 34 needed to control the paint emissions and shall submit a containment plan in accordance I 35 with Section 6-07.3(2). 36 37 6-07.3(9)1 Application of Field Coatings I 38 This section is revised to read: 39 40 An on-site supervisor shall be present for each work shift at the bridge site. I 41 42 Upon completion of erection Work, all uncoated or damaged areas remaining, including 43 bolts, nuts, washers, and splice plates, shall be prepared in accordance with Section 6- 44 07.3(9)F, followed by a field primer coat of a zinc-rich primer and final coats of paint I45 selected from the approved component or performance based paint system in accordance 46 with Section 6-07.3(10)H. . The intermediate, intermediate stripe, and top coats shall be 47 applied in accordance with the manufacturer's written recommendations. I 48 49 Upon completion of erection Work, welds for steel column jackets may be prepared in 50 accordance with SSPC-SP 15. Commercial Grade Power Tool Cleaning. 51 CITY OF EVERETT AMENDMENTS PACIFIC AVENUE TO INTERURBAN TRAIL BICYCLE SAFETY PROJECT 8/12/2019 1 STATE FUND#HLP PBI7(014); COE#PW3688 Page AM-49