Laserfiche WebLink
1 Each coat shall be dry before the next coat is applied. All coats applied in the shop shall <br /> 2 be dried hard before shipment. <br /> 3 <br /> 4 6-07.3(11)B Powder Coating of Galvanized Surfaces <br /> 5 This section is revised to read: <br /> 6 <br /> 7 Powder coating of galvanized surfaces shall consist of the following coats: <br /> 8 <br /> 9 1. The first coat shall be an epoxy powder primer coat conforming to Section 9- <br /> 10 08.2. <br /> 11 <br /> 12 2. The second coat shall be a polyester finish coat conforming to Section 9-08.2. <br /> 13 <br /> 14 6-07.3(11)63 Galvanized Surface Cleaning and Preparation <br /> 15 The first three paragraphs are revised to read: <br /> 16 <br /> 17 Galvanized surfaces receiving the powder coating shall be cleaned and prepared for <br /> 18 coating in accordance with ASTM D 7803, and the project-specific powder coating plan. <br /> 19 <br /> 20 Assemblies conforming to the ASTM D 7803 definition for newly galvanized steel shall <br /> 21 receive surface smoothing and surface cleaning in accordance with ASTM D 7803, <br /> 22 Section 5, and surface preparation in accordance with ASTM D 7803, Section 5.1.3. <br /> 23 <br /> 24 Assemblies conforming to the ASTM D 7803 definition for partially weathered galvanized <br /> 25 steel shall be checked and prepared in accordance with ASTM D 7803, Section 6, before <br /> 26 then receiving surface smoothing and surface cleaning in accordance with ASTM D 7803. <br /> 27 Section 5, and surface preparation in accordance with ASTM D 7803, Section 5.1.3. <br /> 28 <br /> 29 The fourth paragraph (up until the colon) is revised to read: <br /> 30 <br /> 31 Assemblies conforming to the ASTM D 7803 definition for weathered galvanized steel <br /> 32 shall be prepared in accordance with ASTM D 7803, Section 7 before then receiving <br /> 33 surface smoothing and surface cleaning in accordance with ASTM D 7803, Section 5, and <br /> 34 surface preparation in accordance with ASTM D 7803, Section 5.3 except as follows: <br /> 35 <br /> 36 6-07.3(11)65 Testing <br /> 37 Item number 4 in the first paragraph is revised to read: <br /> 38 <br /> 39 4. Adhesion testing in accordance with ASTM D 4541 for 600 psi minimum adhesion for <br /> 40 the complete two-component system. <br /> 41 <br /> 42 The second sentence of the fourth paragraph is revised to read: <br /> 43 <br /> 44 Rejected assemblies shall be repaired or recoated by the Contractor, at no additional <br /> 45 expense to the Contracting Agency, in accordance with the powder coating manufacturer's <br /> 46 recommendation as detailed in the project-specific powder coating plan, until the <br /> 47 assemblies satisfy the acceptance testing requirements. <br /> 48 <br /> 49 6-07.3(12) Painting Ferry Terminal Structures <br /> 50 This section is revised to read: <br /> 51 ' <br /> CITY OF EVERETT AMENDMENTS <br /> PACIFIC AVENUE TO INTERURBAN TRAIL BICYCLE SAFETY PROJECT 8/12/2019 <br /> STATE FUND#HLP PB17(014); COE#PW3688 Page AM-54 <br />