3001 OAKES AVE 2019-11-07 - Laserfiche WebLink

a Interior Lighting - Building Area Method LTG-INT-BLD 2015 Washington State Energy Code Compliance Forms for Commercial Buildings including R2,R3,R4 over 3 stories and all R1 Revised August 2016 Project Title: Carnegie Building Restoration Date 9/11/2017 Calculation o o Addition- o Addition For Building Department Use Area"°TE8 staid alone +existing o Spaces where<50%of ® Spaces where>_50%of o luminaires are replaced luminaires are replaced LPA ® Standard O Additional Efficiency Package Option o Calculation C406.3 Reduced Interior Lighting Power lnebteticcosp404533e4MdtlitlroviiirremitierhiltRikshall be 25%lower than the Target LPA. Type Maximum Allowed Lighting Wattage NOTE Location(plan#, 1 Gross Interior Allowed Watts Allowed Building Area room#,or ALL) Area Description Area in ft2 Watts per ft2 (watts/ft2 x area) Office ALL General Use 9000 0.66 5940 Total 9000 1 Proposed Lighting Wattage Location(plan#, Number of Watts per Building Area room#) Fixture Description NOTE 2,3,4,5 Fixtures Fixture NOTE 6 Watts Proposed OFFICE ALL L1 2X4 LAY IN 72 32 2304 OFFICE ALL L2 1X4 PENDANT 6 24 144 OFFICE ALL P1 LED PENDANT 6 50 300 OFFICE ALL C1 RECESSEDDOWNLIGHT 38 15 570 OFFICE ALL Fl STRIP LIGHT 32 32 1024 OFFICE ALL W1 VANITY LED 4 31 124 OFFICE ALL X1 EXIT 2 Compliance by Building Area"°'h' Total Allowed Total Proposed Interior Lighting Building Area Warnings Watts Watts Power Allowance Office 5940 4466 COMPLIES Confirm all fixtures are reported under proposed lighting-low watts relative to maximum allowed. Note 1-List all unique building areas per Table C405.4.2(1)that occur in the Totals 5940 I 4466 project scope. Select building area category from drop down menu. Note 2-Proposed fixtures must be listed in the building area in which they occur.List all proposed lighting fixtures including exempt lighting equipment and existing-to-remah fixtures. Note 3-For proposed Fixture Description,indicate fixture type,lamp type(e.g. T-8),number of lamps in the fixture,and ballast type(if included). For track fighting,list the length of the track(in feet)in addition to the fixture,lamp,and ballast information. Note 4-For lighting equipment eligible for exemption per C405.4.1,note exception number and leave Watts/Fixture blank. Note 5-Existing-to-remah fixtures shall be included in the Proposed Lighting Wattage table in the same manner as new fixtures. Identify as existing in fixture description. Note 6-For proposed Watts/Fixture enter the luminaire wattage for installed lamp and ballast using manufacturer or other approved source.For luminaires with screw-h lamps,enter the manufacturer's listed maximum input wattage of the fixture(not the lamp wattage).For low voltage lighting, enter the wattage of the transformer. For fine voltage track/busway systems,enter the larger of the attached luminaire wattage or