Road Construction Northwest Inc 12/31/2019

I CITY OF EVERETT SPECIAL PROVISIONS Drawing is received until it is returned to the Contractor. The Contractor shall obtain the Engineer's written approval before proceeding with the Work represented by the ' Working Drawing. 5. Type 3E —Same as a Type 3 Working Drawing with Engineering as described below. Supplement 1-05.3 as follows: The Contract Documents include Plans that show such details as are reasonably necessary to give a comprehensive understanding of the Work. The Contractor shall submit alterations affecting the requirements and information in the Plans in writing to the Engineer for approval prior to performing such Work. The Engineer may supplement the Plans with additional drawings and explanations, consistent with the purpose and intent of the original Plans, to detail and illustrate the 1 Work. The Contractor shall perform the Work according to these supplemental drawings and explanations. In addition to supplemental drawings furnished by the Engineer, the Contract Documents may also be supplemented by Type 1, Type 2 or 2E, and Type 3 or 3E Working Drawings prepared by the Contractor, material supplier, or manufacturer, when necessary or as required by the Contract Documents to detail and illustrate portions of the Work. All types of Working Drawings shall be reviewed by the Engineer before work pursuant to those Working Drawings is performed. Type 3 and 3E Working Drawings may include, and not be limited to, shop details, erection plans, masonry lay-out diagrams, reinforcing steel and bending diagrams, post tensioning plans, shoring, cribbing, cofferdam, or falsework plans, formwork plans, or hydraulic items. Type 2 and 2E Working Drawings may include, and not be limited to, Catalog cuts or standard plans for commonly used manufactured items. The Contractor shall be fully responsible for the accuracy of dimensions and details on Working Drawings, and for complete conformity with the Contract Documents, even if the Working Drawings have been approved by the Engineer, or if the Contractor and the Engineer agree on dimensions and details. The City does not accept Working Drawings as accurate or adequate, and does not take responsibility for, or warrant that Working Drawings will meet Contract requirements. Engineers review of Working Drawings shall not relieve Contractor from responsibility for variation from the requirements of the Contract Documents unless Contractor has in ' writing called the Engineers attention to each such variation at the time of submission, and the Engineer has given written approval of each such variation by a specific written notation thereof incorporated in or accompanying the returned Working Drawing; nor will review by Engineer relieve Contractor from responsibility for errors or omissions in the ' Working Drawings or from responsibility for having complied with the provisions of this section. The Bid prices shall include all costs for furnishing Working Drawings and Submittals. The following listed sections of the Standard Specifications and Special Provisions require Working Drawings that may or may not be applicable to this specific project. This list is supplied as an aid to the Contractor and is by no means complete. Submittal requirements may be found in 1-05.3(1) or elsewhere in these Special Provisions. DIVISION 2 EARTHWORK ' 2-09.3(3)D Shoring, Cribbing, and Cofferdams-Shop Drawings DIVISION 7 DRAINAGE STRUCTURES, STORM SEWERS, SANITARY SEWERS, WATER MAINS, AND CONDUITS I Watermain Replacement"U" Division 1 —GENERAL REQUIREMENTS October 1, 2019 1 WO No—UP3698 SP—61