3530 COLBY AVE COCOON HOUSE 2020-01-13

Lighting, Motor, and Electrical Permit Checklist, Pg. 1 LTG-CHK 2015 Washington State Energy Code Compliance Forms for Commercial Buildings including R2,R3,R4 over 3 stories and all R1 Revised August 2016 Project Title: COCOON HOUSE YOUTH CENTER Date 10/6/2017 The following information is necessary to check a permit application for compliance with the lighting,motor,and electrical requirements in the Washington State Energy Code,Commercial Provisions. Applicability Location in Building Department (yes,no,na) Code Section Component Compliance information required in permit documents Documents Notes LIGHTING CONTROLS Lighting controls, For all lighting fixtures,indicate lighting control method on Yes C405.2 plans for spaces and lighting zone(s)served,or exception A SERIES NA general taken Luminaire level Indicate on plans all fixtures provided with LLLC in lieu of Yes C405.2 lighting controls C405.2 lighting controls;provide description of control A SERIES NA (LLLC) capabilities and performance parameters For permanently installed lighting fixtures in dwelling units, Lighting in dwelling indicate lighting control method on plans for spaces and Yes C405.1 units lighting zone(s)served,or demonstrate compliance with high A SERIES NA efficacy exception C405.2.3 Indicate on plans the method of manual lighting control C405.2.1.1 (whether combined with occupancy sensor,automatic light Yes C405.2.2.2 Manual controls reduction, daylight responsive or specific application controls), A SERIES NA C405.2.4 location of manual control device and area or specifice C405.2.5 application it serves C405.2.2.1 Manual interior Indicate on plans which method of manual 50%lighting load Yes C405.2.2.2 reduction is provided,or whether lighting load is reduced via A SERIES NA C405.2.3 lighting controls occupancy sensors or daylight responsive controls Indicate on plans the method of automatic shut-off control during unoccupied periods(occupancy sensor or time switch) A SERIES NA Yes C405.2.2 Method of automatic for all lighting zones; shut-off control Indicate locations where automatic shutoff is provided by other methods(occupancy sensor or digital timer switch)or which A SERIES NA time switch control exception applies Indicate on plans the spaces served by occupancy sensors; A SERIES NA Yes C405.2.1 Occupancy sensor Indicate whether occupancy sensor controls are configured to C405.2.1.1 controls be manual-on,automatic 50%-on,or serve a space eligible for A SERIES NA automatic 100%-on per exception Occupancy sensor Indicate aisleways and open areas in warehouse spaces Yes C405.2.1.2 controls- provided with occupancy sensor controls that reduce lighting A SERIES NA warehouses power by 50% Yes C405.2.6 Digital timer switch Indicate required digital timer switch control function when A SERIES NA control is used Yes C405.2.2.1 Automatic time Indicate locations of override switches on plans and the lighting A SERIES NA switch controls zone(s)served,include area sq.ft. Indicate primary and secondary sidelight daylight zone areas A SERIES NA on plans,include sq.ft.; C405.2.4.2 Daylight zones- Indicate toplight daylight zone areas on plans,include sq.ft.; A SERIES NA Yes For small vertical fenestration assemblies(rough opening less C405.2.4.3 Sidelight and toplight than 10 percent of primary daylight zone)where daylight A SERIES NA responsive controls are not required,provide fenestration area to daylight zone calculation(s) Indicate on plans lighting zone(s)served by daylight responsive A SERIES NA controls; Identify sidelight and toplight daylight zones that are not provided with daylight sensing controls and the exception(s) A SERIES NA Yes C405.2.4 Daylight responsive that apply; controls Indicate on plans the lighting load reduction method- continuous dimming,or stepped dimming that provides at least A SERIES NA two even steps between 0%-100%of rated power; Indicate that daylight sensing controls are configured to A SERIES NA completely shut off all controlled lights in the lighting zone Additional controls Identify spaces and lighting fixtures on plans that require Yes C405.2.5 Specific application A SERIES NA lighting controls specific application lighting controls per this section Indicate on plans that display and accent lighting,and display case lighting are controlled independently from both general Yes C405.2.5- Display and accent A SERIES NA area lighting and other lighting applications within the same Items 1&2 lighting space; Indicate manual and automatic lighting control method A SERIES NA