6502 EVERGREEN WAY FIT BODY BOOT CAMP 2020-02-07

• Lighting, Motor, and Electrical Permit Checklist, Pg. 3 LTG-CHK 2015 Washington State Energy Code Compliance Forms for Commercial Buildings including R2,R3,R4 over 3 stories and all R1 Revised Nov 2017 Project Title: FIT BODY BOOTCAMP Ti IDate 1/1/2017 The following information is necessary to check a permit application for compliance with the lighting,motor,and electrical requirements in the Applicability II I Location in I Building Department (yes,no,na} Code Section Component Compliance information required in permit documents Documents ` Notes INTERIOR LIGHTING POWER&EFFICACY Include all luminaires in lighting fixture schedule;indicate fixture types,lamps,ballasts,and manufacturer's rated watts per E2.1 fixture; Identify spaces eligible for lighting power exemption on plans Yes C405.4.1 Total connected and in compliance forms;indicate the exception applied; C405.4.2 Interior lighting power identify lighting equipment eligible for lighting power exemption in fixture schedule and in compliance forms;indicate the exception applied; Indicate that exempt lighting equipment is in addition to general area lighting and is controlled independently Yes C405.3 Exit signs Indicate location of exit signs on plans and rated watts per E2.1 fixture in lighting fixture schedule(maximum 5 watts per side) If high efficacy exception is applied to permanently installed Lighting in dwelling lighting fixtures in dwelling units,indicate in lighting fixture NA C405.1 units-lamp efficacy schedule if lamps in fixtures are high efficacy per R404.1. Calculate percentage of fixtures with high efficacy lamps in project(min 75%to comply with exception). Interior Lighting Power Calculation-Indicate compliance path taken Building Area Complete required compliance forms—proposed wattage per NA C405.4.2.1 Method building area does not exceed maximum allowed wattage per building area;identify locations of building areas on plans Complete required compliance forms—total proposed wattage Yes C405.4.2.2 Space-By-Space does not exceed maximum allowed wattage;identify locations o SEPARATE Method space types on plans,including retail display areas,lobby art&!SHEETS exhibit display areas,and ceiling heights as applicable ADDITIONAL EFFICIENCY PACKAGE OPTION-REDUCED INTERIOR LIGHTING POWER DENSITY To comply with additional efficiency package option, Reduced lighting demonstrate in complianceliforms that total connected interior NA C406.3 power density lighting wattage is 25%less than the total maximum allowed lighting wattage via Building Area Method or Space-By-Space Method Reduced lighting For project with dwelling units,to comply with additional power density- efficiency package option indicate in lighting fixture schedule if NA C406.3 dwelling unit lamp lamps in interior fixtures have efficacy rating of 60 lumens per efficacy watt or more.Calculate percentage of fixtures with lamps that have this efficacy rating(min 95%to comply with option) EXTERIOR LIGHTING POWER&EFFICACY Include all luminaires in lighting fixture schedule;indicate fixture types,lamps,ballasts,and manufacturer's rated watts per fixture; Total connected Identify exterior applications eligible for lighting power NA C405.5,2 exterior lighting exemption on plans and In compliance forms;indicate exception power applied; Indicate that exempt exterior lighting is controlled independently from non-exempt exterior lighting;include exception claimed for each fixture or group of fixtures under exception category NA Table Exterior lighting zone Indicate building exterior lighting zone as defined by the AHJ C405.5.2(1) Exterior building For building grounds fixtures rated at greater than 100 watts NA C405,5.1 grounds lighting that are complying based on efficacy,indicate rated lamp efficacy(in lumens per watt)in fixture schedule _ Exterior lighting Complete required compliance form—proposed wattage for NA C405.5.2 power calculations exterior lighting plus base site allowed does not exceed maximum allowed