6502 EVERGREEN WAY FIT BODY BOOT CAMP 2020-02-07

Lighting, Motor, and Electrical Permit Checklist, Pg. 4 LTG-CHK 2015 Washington State Energy Code Compliance Forms for Commercial Buildings including R2,R3,R4 over 3 stories and all R1 Revised Nov 2017 FIT BODY BOOTCAMP TI Date 1/1/2017 The following information is necessary to check a permit application for compliance with the lighting,motor,and electrical requirements in the Applicability Location in 1 Building Department (yes,no,na) Code Section Component Compliance information required in permit documents Documents I Notes LIGHTING ALTERATIONS Where a 50%of existing luminaires in interior space(s)or parking garage are replaced;indicate compliance path(building area or space-by-space method);include all new and existing-to remain luminaires in compliance form(LTG-INT-BLD or LTG- INT-SPACE);indicate proposed lighting wattage does not Interior and parking exceed maximum allowed per compliance path NA C503.6 garage lighting fixture alterations Where<50%of existing luminaires in interior space(s)or parking garage are replaced;indicate total existing lighting wattage in each space prior to alteration;include all new and existing-to-remain luminaires in LTG-INT-SPACE form;indicate proposed total lighting wattage in alteration area does not exceed total existing lighting wattage prior to alteration Where a 50%of existing exterior lighting wattage is replaced; Include all new and existing-to-remain luminaires in LTG-EXT form;indicate proposed total exterior lighting wattage does not exceed maximum allowed Exterior lighting NA C503.6 fixture alterations Where<50%of existing exterior lighting wattage is replaced; indicate total existing lighting wattage prior to alteration;include all new and existing-to-remain luminaires in LTG-EXT form; indicate proposed total exterior lighting wattage does not exceec total existing wattage prior to alteration Where new wiring is installed to serve new interior luminaires Interior lighting wiring and/or luminaires are relocated to a new circuit;indicate NA C503.6 alterations lighting controls are provided(as applicable)-manual (C405.2.3);occupancy sensor(C405.2.1);daylight responsive (C405.2.4);specific application(C405.2.5);exit signs(C405.3) Exterior lighting Where new wiring is installed to serve new exterior luminaires NA C503.6 wiring alterations and/or luminaires are relocated to new circuit;Indicate exterior lighting controls are provided(C405.2.7) Where a new lighting panel is installed or an existing panel Is Lighting panel moved(all new raceway and conductor wiring);indicate lighting NA C503.6 alterations controls are provided(as applicable)-same provisions as wiring alterations;time switch controls and manual light reduction controls(C405.2,2) Where interior space(s)is reconfigured(permanently installed NA C503,6 Interior space walls or ceiling-height partitions);indicate lighting controls are reconfiguration provided(as applicable)-same provisions as lighting panel alterations Identify existing luminaires being upgraded with bulb and I or NA C504.2 Lighting repairs ballast replacement;indicate fixture alteration does not increase existing fixture wattage Identify spaces on plans where the building area type or space use type is being changed from one type to another per Tables C405.4.2(1)or(2) NA C505.1 Change of space use Indicate compliance path(building area or space-by-space method);include all new and existing-to-remain luminaires in compliance form(LTG-INT-BLD or LTG-INT-SPACE);indicate proposed lighting wattage does not exceed maximum allowed per compliance path RECEPTACLES Identify all controlled and uncontrolled receptacles on electrical plans in each space in which they are required;include El 0/E2.0 Controlled receptacle configuration such as spacing between controlled Yes C405.10 receptacles and uncontrolled,duplex devices,etc; Indicate on plans whether the method of automatic control for each controlled receptacle zone is by occupant sensor or E1.0/E2.0 programmable time-of-day control