1519 WALNUT ST 2020-04-02 - Laserfiche WebLink

Components must be listed and approved for use together. Changes to plans must include new drawings and calculations and must be approved by the Fire Department Plan Reviewer prior to installation. Fire alarm installation is subject to field inspection by a Fire Department Inspector. An approved set of plans and the Engineering & Public Services Department electrical permit must be present for any installation inspection. Fire alarm systems shall be installed under permit of the City of Everett Engineering & Public Services Department. Electrical inspections and approval are required prior to calling for acceptance tests. Call (425) 257-8810 for permit information. The absence of working phone lines for the alarm system will be cause for postponing Fire Department inspection and testing and shall result in denial of occupancy. A copy of NFPA 72 Record of Completion form must be filled out prior to final occupancy (NFPA 72, 2010 Edition, Chapter 10, page 114). Call for design requirements per Authority Having Jurisdiction. Automatic smoke detection is required. 5. For buildings with two or more floors, including sub-floors, the alarm system must call point-by- point reporting to an alarm center. Attic heat detectors are required. 6. Carbon monoxide alarms must be installed in all new residential construction in R-1,R-2, and R-3 occupancies per 2012 IFC, Section 908.7 (WA State Amendment). 7. Floors and sub-floors at or above grade in buildings (other than parking garages) shall be marked with numbers, in ascending order, beginning with the number "1" (for the ground floor or first floor), then "2", "3", etc. Letters shall be used only to designate specific areas as detailed below. Floors below grade in buildings (other than parking garages) shall be marked with the letter "B" (when there is only one floor below grade). When there is more than one floor below grade,they shall be marked with the letter"B" followed by numbers, in descending order,beginning with the number "1" (for the floor immediately below the ground floor or first floor), then "2", "3", etc. Example — `B 1", "B2", "B3", in descending order. Mezzanines shall be marked with the letter "M". When there is more than one mezzanine,they shall be marked with the letter"M" followed by numbers, in ascending order. Example—"Ml", "M2", etc. Parking garages shall use the letter "P"to designate floors. When there is only one parking level at or above grade,it shall be marked with the letter "P". When there is more than one parking level at or above grade, they shall be marked with the letter "P" followed by numbers, in ascending order. Example— "P1" "P2", etc. When there is only one parking level below grade, it shall be marked"P01". When there is more than one parking level below grade, they shall be marked with the letter"P"followed by numbers, in descending order. Example — "P01", "P02", etc. Large parking structures may use letters to designate columns for ease of locating automobiles. Example—"Floor P3, Column E". 8. A room numbering footprint shall be provided to the Fire Marshal's Office for approval of floor/building numbering. 9. Trash Collection- Dumpsters over 1.5 cubic yards capacity shall be located a minimum of 5 feet from the building(IFC 304.3.3 and 304.3.4, 2012 Edition). 10. A building footprint and lot layout for this project shall be provided to the Fire Marshal's Office on CD/DVD. Planning Department requirements