101 E MARINE VIEW DR BUSY BEAVER RECYCLING 2016-05-25

16)Easement Marking- Fire apparatus access roads on easements shall be marked whenever necessary to maintain the unobstructed minimum required width of roadways. The easement shall be marked as follows: • Where directed by the Fire Code Official,specific areas shall be designated and those areas are to be marked with diagonal striping across the width of the fire lane. Diagonal marking shall be used in conjunction with painted curbs and/or edge striping and shall run at an angle of 30 to 60 degrees from one side to the other. These diagonal lines shall be in red traffic paint,parallel with each other,at least 6 inches in width and 24 inches apart. Lettering shall appear as above. • Secondary access to Riverside Road must remain accessible and unblocked. 17)Fire Hydrants-Locations as planned are acceptable.All hydrants in the area must be in working condition and accessible. 18)Fire Alarm System-An approved automatic fire detection system shall be provided as required by City Ordinance No. 3021-07,Chapter 16.76,of the Everett Municipal Code. Plans for such system shall be submitted to the Fire Code Official for review and approval prior to installation. Submittal shall include cut sheets of all equipment intended for use. Appropriate trip tests,witnessed by a Fire Department Inspector,shall be performed,along with a certificate of completion,prior to final acceptance of the system. • Fire alarm systems shall be installed according to NFPA Chapter 72. Installation of fire alarm components,including basic wiring,may not commence before plans are approved by the Fire Department Plan Reviewer. Fire alarm drawings must be professionally rendered,in sufficient detail, and must be internally consistent. Riser diagrams must match installation plans and load calculations. Components must be listed and approved for use together. Changes to plans must include new drawings and calculations and must be approved by the Fire Department Plan Reviewer prior to installation. Fire alarm installation is subject to field inspection by a Fire Department Inspector. An approved set of plans and the Engineering&Public Services Department electrical permit must be present for any installation inspection. • Fire alarm systems shall be installed under permit of the City of Everett Engineering&Public Services Department. Electrical inspections and approval are required prior to calling for acceptance tests. Call(425)257-8810 for permit information. • The absence of working phone lines for the alarm system will be cause for postponing Fire Department inspection and testing and shall result in denial of occupancy. • A copy of NFPA 72 Record of Completion form must be filled out prior to final occupancy (NFPA 72,2007 Edition,page 72-33). • Call for design requirements per Authority Having Jurisdiction. • Automatic smoke detection is required. SEPA10 035