3313 OAKES AVE A B 2020-07-14 - Laserfiche WebLink

BLOWER DOOR TEST RESULTS BDT j€Blower Door Testing NW Date of Test: 2�J 425-312-3914 •BlowerDoorNW.com Technician Name: oda (�� `,r' blowerdoorschedule'd) mail.com • Job Site Information Permit#: Address and Lot Number: t _, `y& Ave v e City: E v1414 i Zip Code: Cond. Floor Area(ft2): { 2-4 Age of House: &! Source(check one): Plans ❑Estimated ❑Measured Test Results APass ❑Fail ❑Could Not Complete L . l Volume e810 ACH50 Test Target 5 5-7 S CFM@50Pa Ring(check one if applicable): ❑Open ❑A AB ❑C Blower Door Fan Location: V DdZ:704{ Weather Conditions: V.,a(A)r) Results shall be reported as Air Changes per Hour at 50 Pascals(ACH50)and shall be calculated as follows: ACH50=(CFM50 x 60)/Volume Where: CFM50=Blower door fan flow at 50 Pascal pressure difference Volume=Conditioned Floor Area of the housing unit x ceiling height • 2015 Washington State Energy Code reference: R402.4.1.2 Testing.The building or dwelling unit shall be tested and verified as having an air leakage rate of not exceeding 5 air changes per hour.Testing shall be conducted with a blower door at a pressure of 0.2 inches w.g.(50 Pascals).Where required by the code official,testing shall be conducted by an approved third party.A written report of the results of the test shall be signed by the party conducting the test and provided to the code official.Testing shall be performed at any time after creation of all penetrations of the building thermal envelope.Once visual inspection has confirmed sealing(see Table R402.4.1.1),operable windows and doors manufactured by small business shall be permitted to be sealed off at the frame prior to the test. During testing: I.Exterior windows and doors,fireplace and stove doors shall be closed,but not sealed,beyond the intended weatherstripping or other infiltration control measures; 2.Dampers including exhaust,intake,makeup air,backdraft and flue dampers shall be closed,but not sealed beyond intended infiltration control measures; 3.Interior doors,if installed at the time of the test,shall be open,access hatches to conditioned crawl spaces and conditioned attics shall be open; 4.Exterior openings for continuous ventilation systems and heat recovery ventilators shall be closed and sealed; 5.Heating and cooling systems,if installed at the time of the test,shall be turned off;and 6.Supply and return registers,if installed at the time of the test,shall be fully open.