Laserfiche WebLink
• <br /> KP Roof Repairs and Roof Improvements Project Section 07600 <br /> Community.Transit,ITB#2019-028 Sheet Metal Roofing and Siding <br /> F. All work pertaining to the installation of membrane and flashing shall only be completed by <br /> Applicator personnel and authorized by the manufacturer in those procedures. <br /> 1.07 WARRANTY <br /> A. Sheet Metal Coating Warranty: Provide the owner with the manufacturer's standard <br /> coating and substrate warranty. <br /> 1. Warranty Period: Twenty-five(25)years from date of Substantial Completion. <br /> B. Contractor's Warranty: Submit roofing Installer's warranty, in writing, signed by Installer, <br /> covering Work of this Section, including all components of sheet metal roofing panels, sheet <br /> metal siding panels, and related flashing transitions to perform in a weather-tight manner and <br /> free of defect for the following warranty period: <br /> 1. Warranty Period: Two (2) years from date of Substantial Completion. <br /> 1.08 DEMOLITION <br /> A. Owner may occupy the buildings during the roof replacement project. Coordinate demolition <br /> with the CTPM. <br /> B. Regulatory Requirements: <br /> 1. Comply with governing EPA and PSAPCA notification regulations before starting <br /> demolition. Comply with hauling and disposal regulations of authority having jurisdiction. <br /> 1.09 PRODUCT DELIVERY, STORAGE, AND HANDLING <br /> A. Delivery: Material shall be delivered to Project site in the manufacturer's original sealed and <br /> labeled containers and in quantities sufficient to allow continuity of application. Labels shall <br /> clearly indicate manufacturers name, product brand name and type, date of manufacture, and <br /> directions for storing and mixing with other components. <br /> B. Storage: Obtain permission from a Structural Engineer for any roof top storage. If roof top <br /> storage of materials is used, do not exceed the allowable load for the structure. Handle and <br /> store roofing materials and place equipment in a manner to avoid permanent deflection of <br /> deck. Place all materials on pallets and fully protected from moisture. <br /> C. Stack metal panels horizontally on platforms or pallets, covered with suitable weathertight <br /> and ventilated covering. Store metal panels to ensure dryness, with positive slope for <br /> drainage or water. Do not store metal panels in contact with other materials that might cause <br /> staining, denting, or other surface damage. Comply with manufacturer's written instructions <br /> for handling, storing, and protecting during installation. The manufacturer wrapping will not <br /> be considered sufficient weather protection. <br /> D. Handling: Material shall be handled in such a manner as to preclude damage and <br /> contamination with moisture or foreign matter. <br /> E. Store liquid materials in their original undamaged containers in a clean, dry, protected <br /> location and within the temperature range required by roofing system manufacturer. Protect <br /> stored liquid material from direct sunlight. <br /> 1. Discard and legally dispose of liquid material that cannot be applied within its stated shelf <br /> life. <br /> Construction Documents <br /> 07600-3 3/9 <br />