2300 KASCH PARK RD 2020-12-31 - Laserfiche WebLink

k KP Roof Repairs and Roof Improvements Project Section 07600 Community Transit, ITB#2019-028 Sheet Metal Roofing and Siding F. All flammable materials shall be stored in a cool, dry area away from sparks and open flames. Follow precautions outlined on containers or supplied by material manufacturer/supplier. G. All materials which are determined to be damaged by the Owner Representative or the manufacturer are to be removed from the job site and replaced at no cost to the Owner. 1.10 PROJECT CONDITIONS. A. Weather Limitations: Proceed with installation only when existing and forecasted weather conditions permit assembly of metal panels to be performed according to manufacturer's written instructions and warranty requirements. B. The Applicator shall follow all safety regulations as required by WISHA, OSHA and any other applicable authority having jurisdiction. C. The Applicator shall take precautions that storage and/or application of materials and/or equipment does not overload the roof deck or building structure. D. Site cleanup, including both interior and exterior building areas that have been affected by construction shall be completed to the Owner's satisfaction. All finishes shall be restored to the pre job condition. E. Sheet metal roof panels are slippery when wet or covered with snow, frost, or ice. Working on surfaces under these conditions is hazardous. Appropriate safety measures must be implemented prior to working on such surfaces. Always follow WISHA, OSHA and other relevant fall protection standards when working on roofs. PART 2 MATERIAL 2.01 SHEET METAL PANELS AND ACCESSORIES A. Basis-of-Design Roof Panel Product: Factory formed prefinished through fastened roof panel, match existing sheet metal roof panel profile. AEP Span PBR Panel or approved equal. 1. Exterior finish: PVDF (Kynar 500), color to be chosen by the CT-PM 2. Panel gauge: 24 gauge 3. Panel width: 36 inch 4. Panel height: 1%4 inch Construction Documents (iciII) 9 07600-4