607 RIVERSIDE RD 2021-01-29 - Laserfiche WebLink

• 12. The project proposes to utilize a 12-inch storm drain, located in the access road located along the southern property line, as a high-flow bypass for the project. As part of the building permit approvals, the applicant shall demonstrate that the 12-inch pipe has enough capacity to carry the 25-year storm from its contributory area in accordance with City pipe system conveyance requirements. In particular, it must be shown that high flows will not flood the access roadway, overflow to the west, and enter the storm drainage system for Riverside Road. 13. Approval of construction plans will require demonstration that all pertinent standards and regulations are met. 14. A fire hydrant is required within 200 driving feet but not closer than 50 feet of every structure. 15. A fire hydrant is required within 350 driving feet of every structure. The hydrant(s) must meet City specifications. 16. City streets are to be kept clear of dirt and debris at all times during construction. Dust suppression and street cleaning must occur as directed by the Public Works Inspector. 17. A one year warranty is required on the public improvement for an amount not less than 10% of the cost of construction and shall run for one year from the date of final approval/issuance of the first Occupancy Permit. 18. Lack of comment on the plans submitted with the application does not constitute approval of these plans. 19. As-builts of storm sewer, sanitary sewer, and water systems will be required to be submitted per City Design and Construction Standards and Specifications for Development. 20. Any broken or damaged sidewalk shall be repaired/replaced per the City Public Works Inspector. 21. If the proposed fill is intended to support structures at a later date,the fill shall be placed in accordance with Appendix J of the International Building Code. Should the applicant not wish to construct a fill intended to support a structure at a later date, the applicant will be required to submit a letter to the City so stating. The letter will be recorded against the property. 22. Walkways must be provided from the building entrance to the public sidewalk.. 23. The construction plans must be designed from a site survey performed by a licensed State of Washington land surveyor. 24. Soil compaction testing shall be performed throughout the construction of the public street and utilities. Density curves shall be submitted to the Public Works Department prior to permits being issued for any aspect of the project. All work performed by the geotechnical engineer or testing lab shall be reported directly to the City Public Works Inspector before covering work can be continued by the contractor. Daily reports shall be kept by the soils investigator/tester and submitted to the Public Works Inspector within 24 hours. 25. All exposed ground must be reseeded within 30 days of the completion of construction. If reseeding is not practical due to weather or seasonal problems, the ground must be covered with mulch as directed by the City Engineer. 26. Temporary erosion control measures for construction activity must be operational prior to commencement of any clearing or earthwork. 4/