8615 7TH AVE SE 2021-02-26 - Laserfiche WebLink

a) The handrails should continue a minimum of 12" past the top riser parallel to the floor. b) The handrails should continue a minimum of one tread depth past the lowest tread at the same angle as the handrail. Sheet A8.6 - Add handrails to the stair plan details 2 & 3.. - Add dimensions to show the 12" extensions to both the upper and lower treads. 6) Both handrails at the top of the stairs to the mezzanine should continue in the direction of travel for at least 12" past the top riser. Section 1014.6. Sheet A8.6 - Add handrails to the stair plan details 2 & 3. - Add dimensions to show the 12" extensions to both the upper and lower treads. 7) Doors 1 1 1 C are required side exits per Section 1029.3. As such, emergency egress lighting should be provided (or confirmed existing) for the pathway through the doors through to the adjacent school exit. Section 1008.3.2. Sheet A2.1 - Add note "EXISTING LIGHT FIXTURE. CONTRACTOR TO ENSURE FIXTURE IS ON EMERGENCY BATTERY BACK-UP AS REQUIRED FOR EXIT PATHWAY LIGHTING REQUIREMENT." - Add keynote 2.11 "EMERGENCY EGRESS LIGHT FIXTURE. SEE ELECTRICAL." - Add note "NOTE: FOR COMPLETE LIGHTING LAYOUT AND LIGHTING COMPLIANCE FORMS REFER TO THE ELECTRICAL DRAWINGS." Accessibility: 1) The height of the toilet seat should be shown to be between 17"-19". ANSI Section 604.4. Sheet A7.0 - Details 2 & 5 add dimension "18" TYP." 2) The flush controls should be shown on the wide-side of the toilet room. ANSI Section 604.6. Sheet A7.0 - Add Keynote 7.11 "INSTALL FLUSH CONTROLS ON THE SIDE OPPOSITE OF THE WALL." - Add keynote 7.11 to detail 2. 3) It should be clarified how the wood bases specified for the toilet room comply with the non-absorbent requirement in Section 1210.2.1 . Sheet A7.0 - Change keynote 7.7 "4" RUBBER BASE" Sheet A9.0 - Change WB-1 "WOOD BASE' in the Interior Finish Specification schedule to RB-1 "RUBBER BASE". - Change Restroom 120 base to " RUBBER, RB-1"