2514 RAINIER AVE 2022-03-01 - Laserfiche WebLink

46.28.130". Location shall be approved by the Fire Code Official. Per Fire Marshal site visit. 5. Premise Identification - Premises shall be clearly identified by the correct address at the street entry. Buildings shall be clearly identified so as to be visible and legible from the access road. Individual apartments and suites, where applicable, shall be clearly and legibly identified from the access road. EMC 16.03, Section 505.1.1 (Address Posting Policy). 16" numbers to be placed on building. 6. Fire Hydrants - Locations as planned are acceptable. 7. Fire flow for this project is 1,500 GPM. 8. Portable Fire Protection -A portable fire extinguisher with a minimum U.L. rating of 2-A:10- B:C shall be provided within 75 feet of travel on all floors of each building during construction and prior to occupancy. 2015 IFC, Section 906 9. Kitchens - Install a K-type fire extinguisher within 30 feet of the grill and deep fryers. 2015 IFC, 904.12.5.2 10. Commercial Cooking Operations - A ventilating hood and duct system with an approved automatic fire -extinguishing system shall be provided in accordance with the Mechanical Code for commercial -type food heat -processing equipment that produces grease -laden vapors. Note: If class 1 hood system is installed. 11. Fire Alarm System - An approved automatic fire detection system shall be provided as required by City Ordinance No. 3021-07, Chapter 16.76, of the Everett Municipal Code. Plans for such system shall be submitted to the Fire Code Official for review and approval prior to installation. Submittal shall include cut sheets of all equipment intended for use. Appropriate trip tests, witnessed by a Fire Department Inspector, shall be performed, along with a certificate of completion, prior to final acceptance of the system. , Fire alarm systems shall be installed according to NFPA Chapter 72, 2013 Edition. Installation of fire alarm components, including basic wiring, may not commence before plans are approved by the Fire Department Plan Reviewer. Fire alarm drawings must be professionally rendered, in sufficient detail, and must be internally consistent. Riser diagrams must match installation plans and load calculations. Components must be listed and approved for use together. Changes to plans must include new drawings and calculations and must be approved by the Fire Department Plan Reviewer prior to installation. Fire alarm installation is subject to field inspection by a Fire Department Inspector. An approved set of plans and the Engineering & Public Services Department electrical permit must be present for any installation inspection. Fire alarm systems shall be installed under permit of the City of Everett Engineering & Public Services Department. Electrical inspections and approval are required prior to calling for acceptance tests. Call (425) 257-8810 for permit information. The absence of monitoring for the alarm system will be cause for postponing Fire Department inspection and testing and shall result in denial of occupancy. SP 008 Page 5 of 10 �