2000 TOWER ST 2020 RAINIER HALL Plans 2022-11-28

2ND FLOOR RES-l'-ROOMS DEMOLITION POWER PLAN. 2ND FLOOR RESTROOMS DEMOLITION LIGHTING PLAN SCALE: 3 f 4" = V —0" GENERAL NOTES 1. CIRCUIT NUMBERS SHOWN REFER TO PANEL B UNLESS OTHERWISE NOTED. FLAG NOTES 1 PROVIDE LABOR AND MATERIALS AS REQUIRED TO INTERCEPT EXISTING BRANCH CIRCUIT AND MAINTAIN IN CEILING SPACE FOR EXTENSION TO NEW LOCATION. SEE FLAG NOTE 1, SHEET E2.2, FOR ADDITIONAL INFORMATION. NOTESGENERAL 1. CIRCUIT NUMBERS SHOWN REFER TO PANEL L UNLESS OTHERWISE NOTED. DEMOLITION TES 1. VISIT AND EXAMINE THE SITE PRIOR TO CONSTRUCTION TO ASCERTAIN THE CONDITIONS AND LIMITS OF DEMOLITION AND CONSTRUCTION. 2. DISPOSE OF ALL REMOVED EQUIPMENT UNLESS DIRECTED TO DO OTHERWISE BY THESE DOCUMENETS OR THE OWNER. 3. DISCONNECT, REMOVE OR RELOCATE EXISTING ELECTRICAL INSTALLATION AS INDICATED. THIS INCLUDES, BUT NOT LIMITED TO PANELS, LIGHT FIXTURES, WIRING DEVICES, ETC. COORDINATE WITH MECHANICAL PRIOR TO DEMOLITION OF ANY EQUIPMENT. 4. SEE MECHANICAL DRAWINGS FOR HEATERS, EXHAUST FANS, ETC. WHICH MUST BE DISCONNECTED BY DIVISION 26 FOR REMOVAL OR ABANDONMENT BY DIVISION 23. 5. REMOVE ALL CONDUIT, WIRE, BOXES AND FASTENING DEVICES AS REQUIRED TO AVOID ANY INTERFERENCE WITH NEW INSTALLATION. ABANDONED CONDUIT SHALL BE CAPPED AT BOTH ENDS. 6. SYSTEMS WHICH REQUIRE INTERRUPTION OF SERVICE SHALL BE COORDINATED WITH OWNER. 7, REMOVE ALL POWER SYSTEMS AS INDICATED OR REQUIRED TO CLEAR AREA FOR NEW INSTALLATION. 8. RECONNECT ANY EQUIPMENT BEING DISTURBED BY THESE RENOVATIONS YET REQUIRED FOR CONTINUED SERVICE. 9, WHERE WORK (WALL REMOVAL, NEW OR RELOCATED WALL OPENINGS, ETC.) RESULTS IN THE REMOVAL OF LIGHT FIXTURES, DISCONNECT OR RECONNECT AS REQUIRED ALL ACTIVE DEVICES REMAINING ON THE CIRCUIT SYSTEM. 10. EXISTING ELECTRICAL DEVICES ARE BASED ON RECORD DRAWINGS, NOT ALL DEVICES TO BE REMOVED MAY BE SHOWN. CONTRACTOR SHALL VERIFY EXISTING CONDITIONS. ALL RECEPTACLES ON DEMO WALLS TO BE DEMOLISHED. 11. PROVIDE FIRE WATCH AS REQUIRED BY THE AHJ AND NFPA. ®copyright 2019