2131 LAKE HEIGHTS DR 2021-09-07 - Laserfiche WebLink

t , Drew Martin III From: Johnathon Cave <jcave@clarkbarnes.com> Sent: Friday, December 4, 2020 1:18 PM To: Drew Martin Cc: Suzanne Salandi Subject: RE: Permit# B2008-003 -Architectural Drawing Set Thank you Drew, I will have the 12 pg. architectural set printed and to you by Monday morning. Thanks again. Johnathon Cave Interior Designer CLARK I BARNES 1401 West Garfield Street, Seattle,WA 98119 0 (206) 782.8208 ext.814 I D (206) 259.2612 www.clarkbarnes.com From: Drew Martin<dmartin@everettwa.gov> Sent: Friday, December 4, 2020 1:09 PM To:Johnathon Cave<jcave@clarkbarnes.com> Cc:Suzanne Salandi<ssalandi@clarkbarnes.com> Subject: RE: Permit#B2008-003-Architectural Drawing Set Thank you for the clarifications. I haven't performed a thorough review of the hood submittal at this point,which actually haven't been approved yet. But this does help. As previously noted, my commentary is primarily to ensure that there isn't a hole in the design between the two submittals. Specifically regarding exterior supports,this is typically required when there is a long duct run. If the hood is extending horizontally from the wall and is capped with a heavy end piece,some level of framing may still be required. Again, if this is covered in the mechanical drawings, no problem. As a final comment, a general reference to SMACNA standards may not be sufficient if the weight is large (say, more than 50 Ibs). For heavier weights, some detailing and design per ASCE 7-10 Section 13.6 should be performed. I'll be in Monday afternoon, so give me a heads-up when the drawings have been delivered. I've got our assist ready to help me collate the drawings. Drew Martin, P.E.,S.E. im iim Associate Engineer—Commercial Plans Examiner I Permit Services 425.257.8813 13200 Cedar Street, 2nd Floor, Everett,WA 98201 EVERETT Hours: M/W/Th/F: 7:30am-12:00pm & 1:00pm-3:00pm;Tu: 1:0Opm-3:OOpm everettwa.gov I Facebook I Twitter 1