3814 W MUKILTEO BLVD 2021-09-07 - Laserfiche WebLink

• • IP intertek Code Compliance Research Report Total Quality.Assured. CC R R-1043 Issue Date:06-19-2015 Revision Date: 09-18-2019 Renewal Date: 01-01-2020 DIVISION:07 00 00—THERMAL AND MOISTURE PROTECTION 2.0 USES Section:07 2100—Thermal Insulation Section:07 21 19—Foamed-In-Place Insulation Gaco F1850 spray-applied polyurethane foam insulation is used as a nonstructural thermal insulating material on or in interior REPORT HOLDER: and exterior walls,floors,ceilings,and roofs. Gaco,a division of Firestone Building Products Company,LLC 200 4th Avenue South Under the IRC,the insulation may be used as air-impermeable Nashville,TN 37201 insulation when installed in accordance with Section 3.2.3. (800)428-4442 www.gaco.com The insulation may be used as an air barrier when installed as described in Section 3.2.4. REPORT SUBJECT: Gaco F1850 Spray-applied Polyurethane Insulation The insulation may be used as vapor retarder as described in Section 3.2.5. 1.0 SCOPE OF EVALUATION The insulation may be used as a water-resistive barrier on This Research Report addresses compliance with the following exterior walls as described in Section 3.2.6. Codes: -- 2018, 2015, 2012, and 2009 International Building Code° The insulation may be used in Types I, II, Ill, IV, and V (IBC) construction. When used in exterior walls in Types I,II,Ill,and 2018, 2015, 2012,and 2009 International Residential Code° IV construction (IBC), the wall construction must be in (IRC) accordance with Section 4.5. 2018, 2015, 2012, and 2009 International Energy Conservation Code°(IECC) The insulation may be used as duct insulation material when installed as described in Section 4.6. Gaco F1850 has been evaluated for the following properties: Physical properties 3.0 DESCRIPTION Surface-burning characteristics Thermal resistance 3.1 Materials: • Air permeability Air Barrier 3.1.1 Gaco F1850: Gaco F1850 insulation is a closed cell, • Vapor permeance medium-density, polyurethane foam plastic. The insulation Water resistive barrier is a two-component, spray-applied foam plastic with a ▪ Alternative to thermal barriers nominal in-place density of 2.1 pounds per cubic foot. The • Alternative to ignition barriers insulation is produced in the field by combining a polymeric ▪ Use in Types I,II,III,and IV construction isocyanate(A component)with a resin (B component). The insulation liquid components are supplied in 55-gallon drums a Use in Type V construction and 250-gallon totes, and must be stored at temperatures Duct insulation between 40°F and 80°F. The resin (B component) must be protected from freezing temperatures. See Table 1 for applicable Code sections related to these properties. NOTE: This report references the 2018 Code sections. Earlier version of the codes may have different section numbers. 545 E.Algonquin Road •Arlington Heights• Illinois•60005 intertek.com/building lntertek PCA-101 Version:21 December 2017 SFT-CCRR-OP-40b