3000 ROCKEFELLER AVE ADMIN BLDG WEST 2022-05-13

Lighting, Motor, and Electrical Permit Checklist, Pg. 1 LTG-CHK 2015 Washington State Energy Code Compliance Forms for Commercial Buildings including R2,R3,R4 over 3 stories and all R1 Revised August 2016 Project Title: Snohomish County Courthouse Renovation (Date 5/11/2018 ER) The following information is necessary to check a permit application for compliance with the lighting,motor,and electrical requirements in the Washington State Energy Code,Commercial Provisions. Applicability Location in Building Department (yes,no,na) Code Section Component Compliance information required in permit documents Documents Notes LIGHTING CONTROLS Yes C405.2 Lighting controls, For all lighting fixtures,indicate lighting control method on plans E-3XX series and general for spaces and lighting zone(s)served,or exception taken E-9XX series Luminaire level Indicate on plans all fixtures provided with LLLC in lieu of No C405.2 lighting controls C405.2 lighting controls;provide description of control (LLLC) capabilities and performance parameters For permanently installed lighting fixtures in dwelling units, NA C405.1 Lighting in dwelling indicate lighting control method on plans for spaces and units lighting zone(s)served,or demonstrate compliance with high efficacy exception C405.2.3 Indicate on plans the method of manual lighting control C405.2.1.1 (whether combined with occupancy sensor,automatic light E-3XX series and Yes C405.2.2.2 Manual controls reduction, daylight responsive or specific application controls), E-9XX series C405.2.4 location of manual control device and area or specifice C405.2.5 application it serves C405.2.2.1 Manual interior Indicate on plans which method of manual 50%lighting load No C405.2.2.2 reduction is provided,or whether lighting load is reduced via C405.2.3 lighting controls occupancy sensors or daylight responsive controls Indicate on plans the method of automatic shut-off control E-3XX series and during unoccupied periods(occupancy sensor or time switch) E-9XX series Yes C405.2.2 Method of automatic for all lighting zones; shut-off control Indicate locations where automatic shutoff is provided by other methods(occupancy sensor or digital timer switch)or which E-3XX series time switch control exception applies Indicate on plans the spaces served by occupancy sensors; E-3XX series III Yes C405.2.1 Occupancy sensor Indicate whether occupancy sensor controls are configured to C405.2.1.1 controls be manual-on,automatic 50%-on,or serve a space eligible for E-3XX series and automatic 100%-on per exception E-9XX series Occupancy sensor Indicate aisleways and open areas in warehouse spaces No C405.2.1.2 controls- provided with occupancy sensor controls that reduce lighting warehouses power by 50% No C405.2.6 Digital timer switch Indicate required digital timer switch control function when control is used Yes C405.2.2.1 Automatic time Indicate locations of override switches on plans and the lighting E-3XX series and switch controls zone(s)served,include area sq.ft. E-9XX series Indicate primary and secondary sidelight daylight zone areas E-3XX series and on plans,include sq.ft.; E-9XX series C405.2.4.2 Daylight zones- Indicate toplight daylight zone areas on plans,include sq.ft.; NA Yes C405.2.4.3 Sidelight and toplight For small vertical fenestration assemblies(rough opening less than 10 percent of primary daylight zone)where daylight NA responsive controls are not required,provide fenestration area to daylight zone calculation(s) Indicate on plans lighting zone(s)served by daylight responsive E-3XX series and controls; E-9XX series Identify sidelight and toplight daylight zones that are not provided with daylight sensing controls and the exception(s) NA Yes C405.2.4 Daylight responsive that apply; controls Indicate on plans the lighting load reduction method- continuous dimming,or stepped dimming that provides at least E-3XX series and two even steps between 0%-100%of rated power; E-9XX series Indicate that daylight sensing controls are configured to E-3XX series and completely shut off all controlled lights in the lighting zone E-9XX series Additional controls Identify spaces and lighting fixtures on plans that require NA C405.2.5 Specific application specific application lighting controls per this section lighting controls Indicate on plans that display and accent lighting,and display • NA Items 1&2.5- Display and accent case lighting are controlled independently from both general Items lighting area lighting and other lighting applications within the same space; Indicate manual and automatic lighting control method