9001 AIRPORT RD 2021-12-20 - Laserfiche WebLink

• • • T • • • - - ' • I • • ' 2018 WSEC Requirements for Commercial Buildin• cluding Group R2,R3&R4 over 3 stories&all R1 -- •. inistered by©2021 NEEA,All rights reserved The following information is necessary to check a permit application for compliance with the lighting systems,motors and electrical system requirements in the Washington State Energy Code,Commercial Provisions. For questions about this report,contact WSEC Commercial Technical Support at 360-539-5300 or via email at com.techsupport@waenergycodes.com NA Provide calculation of lighting power density of total egress lighting NA If total egress lighting power density is greater than 0.02 W/sq.ft.,indicate on plans egress fixtures requiring automatic shut-off during unoccupied periods NA Indicate method of automatic shut-off control NA C405.4.1 Lighting control of Indicate that exempt interior lighting C405.4.2 exempt interior equipment and lighting located within spaces lighting that are eligible for a lighting power exemption are controlled independently from non-exempt and general area lighting NA C405.2.6 Exterior lighting For decorative exterior lighting,indicate on controls plans automatic daylight shut-off controls,or exception taken NA For exterior lighting that is not decorative, indicate on plans automatic daylight or time- switch shut-off controls and setback controls; or indicate exception taken NA For lighting requiring setback controls, include control sequence that reduces lighting power by at least 30%between 12am-6am,or from 1 hour after closing to 1 hour before opening,or based upon motion sensor NA For building facade and landscape lighting, indicate control sequence for shut-off control is based on dawn-to-dusk and business opening/closing schedule;indicate whether automatic or time switch controls will be provided for this function NA C405.5.2 Lighting control of Indicate that exempt exterior lighting and exempt exterior lighting located within exterior areas/surfaces lighting that eligible for a lighting power exemption are controlled independently from non- exempt exterior lighting NA C405.5.4 Exterior gas-fired Indicate ignition system is a method other lighting appliances then continuously burning pilot light NA C405.2.7 Area controls- Indicate location(s)of master control Master control switch(es)intended to control multiple switches and circuit independent switches;circuit breaker may not power limit be used as a master control switch NA Verify that no 20 amp circuit controlled by a single switch or automatic control is loaded beyond 80% ADDITIONAL EFFICIENCY CREDIT-ENHANCED INTERIOR LIGHTING CONTROLS Page 4/10